Installation Guide

Back Plate
Bolt Nut
Glass Holder
Glass Shade
Socket Ring
VL35472 / VL35473 / VL35474
Mounting Screw
Fixture Wire
Fixture Grounding Wire
Lock Nut
Mounting Plate
Housing Grounding Wire
Green Grounding Screw
Wire Nut
Headless Screw
Outlet Box
1. Thread two headless screws through the mounting plate, and secure them with
four lock nuts (two on each side of the mounting plate). Adjust the length of the
headless screws if necessary.
2. Attach the mounting plate to the outlet box by using two mounting screws.
3. Pull out the outlet wires and the house grounding wire from the outlet box. Make
wire connections using the wire nuts:
---Connect the black wire from the fixture to the black wire from the power source.
---Connect the white wire from the fixture to the white wire from the power source.
---Attach the fixture grounding wire to the mounting plate with the green grounding
screw. Then connect it to the house grounding wire with a wire nut.
Carefully put the wires back into the outlet box.
4. Attach the back plate to the mounting plate by inserting the headless screws, then
secure it with two bolt nuts.
5. Attach the glass shades to the glass holders, then secure them with the socket
rings.
6. Install bulbs (not included). See relamping label at socket area or packaging for
maximum allowed wattage.
7. Turn on the power at the main fuse or circuit breaker box.
070418
ASSEMBLY AND INSTALLATION
INSTRUCTIONS
WARNING: BE SURE TO SHUT OFF POWER AT THE MAIN FUSE OR CIRCUIT
BREAKER BOX BEFORE INSTALLING OR SERVICING THIS FIXTURE.
NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ AND SAVE THIS INSTRUCTION.