Installation Guide

1. Rod Connections:
a. Thread the fixture wire from the fixture through the 6” rod, then
secure the 6” rod onto fixture using the threaded pipe.
b. Thread the fixture wire through the middle rod, and then secure
the middle rod onto the 6” rod using the threaded pipe.
c. Thread the fixture wire through the upper rod, and then secure
the upper rod onto the middle rod using the threaded pipe.
The height can be adjustable to 20", ~ 62" by using the rods.
2. Thread the fixture wire through the collar, coupling kit, canopy,
then secure the rod assembly to the coupling kit.
3. Thread the fixture wire through the nipple, hex nut and mounting
strap. Install the hex nut onto one end of the nipple leaving about
3/8” (10mm) thread exposed. Install same end of nipple by
screwing into coupling kit, secure nipple by tightening hex nut.
4. Attach the nipple to the mounting strap, then secure it with a
washer and hex nut.
5. Attach the mounting strap to outlet box by using two
mounting screws.
6. Pull out the outlet wires and the house grounding wire from
the outlet box. Make wire connections using the wire nuts:
---The black wire from fixture to the black wire from power
source.
---The white wire from fixture to the white wire from power
source.
---Attach the fixture grounding wire to the mounting strap
with the green grounding screw. Then connect it to the
house grounding wire with the wire nut.
Carefully put the wires back into the outlet box.
7. Attach the canopy to the mounting strap, and secure it
with collar.
8. Install a bulb (not included). See relamping label at socket
area or packaging for maximum allowed wattage.
9. Place the shade over glass holder, making sure the harp feeds
through the center hole of shade. Secure shade with a cap and
a finial.
10. Turn on the power at the main fuse or circuit breaker box.
Collar
Canopy
Outlet Box
House Grounding Wire
Wire Nut
Nipple
Mounting Strap
Green Grounding Screw
Hex Nut
Mounting Screw
Upper Rod
Middle Rod
Threaded Pipe
Threaded Pipe
Fixture Wire
6” Rod
ASSEMBLY AND INSTALLATION
INSTRUCTIONS
WARNING: BE SURE TO SHUT OFF POWER AT THE MAIN FUSE OR CIRCUIT
BREAKER BOX BEFORE INSTALLING OR SERVICING THIS FIXTURE.
NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ AND SAVE THESE INSTRUCTIONS.
P0036
Fixture
Shade
Glass Holder
Finial
Bulb Type A Max.100W
(Not Included)
120726
Coupling Kit
Fixture Grounding Wire
Hex Nut
Cap
Contents of Spare Parts:
Assembly Kit
(1 SET)
(4571MM)
12＂Rod
(3 PCS)
(4572RR)
Harp
Threaded Pipe
Washer
6＂Rod
(1 PC)
(4573RR)