Installation Guide

1. Attach the cross bar to the outlet box
by using two mounting screws.
2. Pull out the outlet wires and the house
grounding wire from the outlet box.
Make wire connections by using the
wire nuts:
---Connect the black (hot) wire from
the fixture to the black (hot) wire
from the power source.
---Connect the white (neutral) wire
from the fixture to the white (neutral)
wire from the power source.
---Attach the fixture grounding wire to
the cross bar with the green
grounding screw. Then connect it to
the house grounding wire with a wire
nut.
Carefully put the wires back into the
outlet box.
4. Attach the back plate to the cross bar
by aligning holes, secure the fixture
mounting screws from the side hole of
the back plate into the hole in the side
of the cross bar.
5. Attach the inner bubble glass pillar onto
the glass holder, then place the glass
shade onto the glass holder.
6.Non-replaceable white LED Bulb.
7. Turn on the power at the main fuse or circuit breaker box.
Back Plate
Glass Holder
Green Grounding Screw (D)
Fixture Grounding Wire
Wire Nut (B)
Mounting Screw (E)
Cross Bar (A)
Outlet Box
Fixture Wire
ASSEMBLY AND INSTALLATION
INSTRUCTIONS
WARNING: BE SURE TO SHUT OFF POWER AT THE MAIN FUSE OR CIRCUIT
BREAKER BOX BEFORE INSTALLING OR SERVICING THIS FIXTURE.
NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ AND SAVE THESE INSTRUCTIONS.
T0045 / T0047
LED 9W
Parts:
Glass Shade (F)
121121
Glass Shade (F)
Inner Bubble Glass Pillar (G)
Fixture Mounting Screw (C)
Cross Bar (A)
Parts Number (4602MM)
Wire Nut (B)
Mounting Screw (E)
Fixture Mounting Screw (C)
Green Grounding
Screw (D)
Parts Number (9390CE)
Parts Number (9390CB For T0045)
Parts Number (9391CB For T0047)
Inner Bubble Glass Pillar (G)