Installation Guide

ManualsBrandsCascadia ManualsOutdoor Wall LightsATG10946307

ASSEMBLY AND INSTALLATION

INSTRUCTIONS

WARNING: BE SURE TO SHUT OFF POWER AT THE MAIN FUSE OR CIRCUIT

BREAKER BOX BEFORE INSTALLING OR SERVICING THIS FIXTURE.

NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.

2. READ AND SAVE THESE INSTRUCTIONS.

T0053

Fixture

Back Plate

Page 1

1. Attach the nipple to the mounting strap, then secure it with a washer and hex nut.

2. Attach the mounting strap to the outlet box by using two mounting screws.

3. Pull out the outlet wires and house grounding wire from the outlet box. Make wire connections by

using the wire nuts:

---The black (hot) wire from the fixture to the black (hot) wire from the power source.

---The white (neutral) wire from the fixture to the white (neutral) wire from the power source.

---Attach the fixture grounding wire to the mounting strap with the green grounding screw. Then

connect it to the house grounding wire with a wire nut.

Carefully put the wires back into the outlet box.

4. Attach the fixture to the mounting strap by inserting the nipple, then secure it with the end cap.

CAUTION: With silicone caulking compound, caulk completely around where the back

plate meets with the wall surface to prevent water from seeping into the outlet box.

Mounting Screw (B)

Fixture Wire

End Cap (H)

Nipple (G)

Mounting Strap (A)

Hex Nut (E)

Wire Nut (D)

Washer (F)

Fixture Grounding Wire

Green Grounding Screw (C)

Outlet Box

House Grounding Wire

Parts:

121224

Parts Number (7046DD)

Driver (I) (X1)

Parts Number (4604MM)

Mounting Strap (A)

Mounting Screw (B)

Green Grounding

Screw (C)

Wire Nut (D)

Hex Nut (E)

Washer (F)

Nipple(G)

End Cap(H)

Summary of content (2 pages)

PAGE 1
T0053 ASSEMBLY AND INSTALLATION INSTRUCTIONS WARNING: BE SURE TO SHUT OFF POWER AT THE MAIN FUSE OR CIRCUIT BREAKER BOX BEFORE INSTALLING OR SERVICING THIS FIXTURE. NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements. 2. READ AND SAVE THESE INSTRUCTIONS.
PAGE 2
5. Non-replaceable warm white LED Bulb. 6. Turn on the power at the main fuse or circuit breaker box. Note: The driver is replaceable! Replace the Driver (For T0053) Fig.1 Fig.2 Connector Mounting Screw Connector Driver Mounting Screw Driver Back Plate Back Plate 1. Turn off the power at the main fuse or circuit breaker box. 2. Unsecure the end cap, carefully remove back plate from outlet box. 3. Pull out the wires from the outlet box, Loosen the wire nuts connected with the old driver. 4.