Installation Guide

ManualsBrandsCascadia ManualsVanity LightsATG10946329

ASSEMBLY AND INSTALLATION

INSTRUCTIONS

WARNING: BE SURE TO SHUT OFF POWER AT THE MAIN FUSE OR CIRCUIT

BREAKER BOX BEFORE INSTALLING OR SERVICING THIS FIXTURE.

NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.

2. READ AND SAVE THESE INSTRUCTIONS.

W0057 / W0058

Fixture

121220

1. Unsecure the ball nuts, carefully remove mounting plate from back plate.

2. Attach the mounting plate to the wall.

a) If the wall material is wood:

Attach the mounting plate to the outlet box by using two mounting screws, then secure the dry wall

screws through the set holes to the wall.

b) If the wall material is cement:

Place the mounting plate to the outlet box and mark the target on the wall from the set hole for

drilling two holes. Remove the mounting plate. Drill the holes and thread the anchors into the holes,

then attach the mounting plate to the outlet box by using two mounting screws. Secure the dry wall

screws through the set holes into the anchors.

3. Pull out the outlet wires and the house grounding wire from the outlet box. Make wire connections by

using the wire nuts:

Glass bracket

socket fixer

Bulb Type A Max.100W

(not included)

Back Plate

Fixture Mounting Screw

Lock Nut (D)

Mounting Plate

House Grounding Wire

Green Grounding Screw (B)

Fixture Grounding Wire

Wire Nut (C)

Outlet Box

Fixture Wire

Glass Shade (H)

Ball Nut (E)

Anchor (G)

Dry Wall Screw (F)

Mounting Screw (A)

Parts:

Parts Number (4621MM For W0058)

(4622MM For W0057)

Parts Number (9404FO)

Mounting Screw (A)

Green Grounding

Screw (B)

Wire Nut (C)

Glass Shade (H) (X3)

Anchor (G)

Dry Wall Screw (F)

Lock Nut (D)

Ball Nut (E)

Summary of content (2 pages)

PAGE 1
ASSEMBLY AND INSTALLATION INSTRUCTIONS W0057 / W0058 WARNING: BE SURE TO SHUT OFF POWER AT THE MAIN FUSE OR CIRCUIT BREAKER BOX BEFORE INSTALLING OR SERVICING THIS FIXTURE. NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements. 2. READ AND SAVE THESE INSTRUCTIONS.
PAGE 2
---Connect the black (hot) wire from the fixture to the black (hot) wire from the power source. ---Connect the white (neutral) wire from the fixture to the white (neutral) wire from the power source. ---Attach the fixture grounding wire to the mounting plate with the green grounding screw. Then connect it to the house grounding wire with a wire nut. Carefully put the wires back into the outlet box. 4.