Installation Guide

ManualsBrandsCascadia ManualsPendant LightingATG11573872

Collar (H)

Canopy (I)

Outlet Box

House Grounding Wire

Wire Nut (E)

Nipple (C)

Mounting Strap (A)

Green Grounding Screw (F)

Mounting Screw (D)

Upper Rod

Middle Rod

Lower Rod

Threaded Pipe

Fixture Wire

ASSEMBLY AND INSTALLATION

INSTRUCTIONS

WARNING: BE SURE TO SHUT OFF POWER AT THE MAIN FUSE OR CIRCUIT

BREAKER BOX BEFORE INSTALLING OR SERVICING THIS FIXTURE.

NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.

2. READ AND SAVE THESE INSTRUCTIONS.

P0065

Coupling Kit (G)

Fixture Grounding Wire

Lock Nut (B)

Interior Glass (P)

Parts:

Parts Number (4781MM)

Mounting Screw (D)

Lock Nut (B)

Wire Nut (E)

Mounting Strap (A)

Nipple (C)

Green Grounding

Screw (F)

Coupling Kit (G)

Collar (H)

Canopy (I)

130618

Parts Number (4788RR)

12”Rod (X3)(J)

Parts Number (4786RR)

6”Rod (K)

Parts Number (4787RR)

3”Rod (L)

1. Rod Connections:

a. Thread the fixture wire from the socket through the support

and lower rods, then secure the lower rod onto socket using

the threaded pipe.

b. Thread the fixture wire through the threaded pipe and middle

rod, and then secure the middle rod onto the lower rod using

the threaded pipe.

c. Thread the fixture wire through the threaded pipe and upper

rod, and then secure the upper rod onto the middle rod using

the threaded pipe.

The height can be adjustable to 19-1/2"~58-1/2", by using

the rods.

2. Thread the fixture wire through the coupling kit, collar, canopy,

then secure the rod assembly to the coupling kit.

3. Thread the fixture wire through the nipple, lock nut and mounting

strap. Install the lock nut onto one end of the nipple leaving about

3/8” (10mm) thread exposed. Install same end of nipple by

screwing into coupling kit, secure nipple by tightening lock nut.

Exterior Glass (O)

Socket

Set Screw-2 (N)

Set Screw-1 (O)

Parts Number (4790SS)

Set Screw-1 (X3)(M)

Parts Number (4789SS) Parts Number (9462CW)

Exterior Glass (O)

Threaded Pipe

Set Screw-2 (X3)(N)

Parts Number (9463FO)

Interior Glass (P)

Lock Nut (B)

Support

Bulb T10 Max.75W

(not included)

Metal Ring

Summary of content (2 pages)

PAGE 1
P0065 ASSEMBLY AND INSTALLATION INSTRUCTIONS WARNING: BE SURE TO SHUT OFF POWER AT THE MAIN FUSE OR CIRCUIT BREAKER BOX BEFORE INSTALLING OR SERVICING THIS FIXTURE. NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements. 2. READ AND SAVE THESE INSTRUCTIONS.
PAGE 2
4. Attach the nipple to the mounting strap, then secure it with lock nut. 5. Attach the mounting strap to outlet box by using two mounting screws. 6. Pull out the outlet wires and the house grounding wire from the outlet box. Make wire connections by using the wire nuts: ---The black (hot) wire from fixture to the black (hot) wire from power source. ---The white (neutral) wire from fixture to the white (neutral) wire from power source.