Installation Guide

1. Attach the nipple(-a) to the mounting strap, then secure it
with a washer and hex nut.
2. Attach the mounting strap to the outlet
box by using two mounting screws.
3. Two sizes of the pipes, 6＂L (x2) and
12＂L (x8), are attached in the hardware
package, choose the desired installation
height you need. Then thread the fixture
wires through the pipes and nipples as
shown in the right graph.
The height can be adjustable to
14-3/4＂, 26-3/4＂, 38-3/4＂, 50-3/4＂
or 62-3/4＂ by using the pipes.
4. Screw all pipes together until securely
by using the nipples, and then lock to
the bar securely.
5. Slide the canopy down through the nipple
of the top pipe, secure them respectively
with spring pads, hex nuts and grounding
pad. See the graph for correct location.
6. Pull out the outlet wires and house grounding
wire from the outlet box. Make wire connections using the wire nuts:
---The black wire from the fixture to the black wire from the power source.
---The white wire from the fixture to the white wire from the power source.
---Attach the fixture grounding wire to the mounting strap with the green grounding screw. Then
connect it to the house grounding wire with a wire nut.
Carefully put the wires back into the outlet box.
7. Attach the canopy to the mounting strap by inserting the nipple, then secure it with a finial.
8. Attach the glass shades to the glass holders, then secure them with the spacer and socket rings.
9. Install bulbs (not included). See relamping label at socket area or packaging for maximum allowed
wattage.
10. Turn on the power at the main fuse or circuit breaker box.
ASSEMBLY AND INSTALLATION
INSTRUCTIONS
WARNING: BE SURE TO SHUT OFF POWER AT THE MAIN FUSE OR CIRCUIT
BREAKER BOX BEFORE INSTALLING OR SERVICING THIS FIXTURE.
NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ AND SAVE THESE INSTRUCTIONS.
P0005 / P0006
Wire Nut
Mounting Screw
Nipple(-a)
Canopy
Mounting Strap
Green Grounding Screw
Hex Nut
Washer
Outlet Box
House Grounding Wire
Fixture Grounding Wire
Finial
Top Pipe
Nipple
Pipe
Bar
Glass Holder
Glass Shade
Spacer
Socket Ring
Nipple
Lock Ring
Hex Nut
Washer
Grounding Pad
Metal Pad
Bulb Type A Max.100W
(not included)
Contents of Spare Parts:
Assembly Kit
(1 SET)
(4479MM For P0005)
(4481MM For P0006)
Glass Shade
(4 PCS)
(950005FO For P0006)
(950005HL For P0005)
GND
120320
6＂Pipe
(2 PCS)
(4480RR For P0005)
(4482RR For P0006)
12＂Pipe
(8 PCS)
(4479RR For P0005)
(4481RR For P0006)
Socket Ring
(4 PCS)
(4479KK)