Installation Guide

4. Unscrew the caps from the connector beneath the canopy and then separate
the connector. (See Fig 6)
CAUTION: BE CAREFUL NOT TO SNAP THE WIRE WHEN SEPARATING
THE CONNECTOR, THIS WILL CAUSE THE WIRE TO DISCONNECT.
5. Attach the flexible track onto the slot of the connector.(See Fig 7) The brass
clips of the connector must be connected with the brass tabs and ground
tab of the track.(See Fig 8) (CAUTION: To ensure the light works,
correctly make sure the connection of the connector and the flexible
track is correct.) Attach both halves of the connector together and then
screw the caps and plastic screws on tightly.
6. Attach the flexible track onto the slot of the other rail support placed in the
other side of the canopy on the ceiling. Connect both halves of the rail
support together back. Then screw the caps on tightly. (See Fig 4 & Fig 5)
7. Shape the flexible track as you desire. Mark the desired positions and drill
them on the ceiling for the rest of the rail supports. (See Fig 9-1 & Fig 9-2).
8. Repeat the rail supports installations as mentioned on the above step 2.
(See Fig.3 ).Then repeat step 3 and step 6 to install the flexible track onto
the rest of rail supports.
Flexible track
Fig. 7
Fig. 5
Fig. 8
Fig 9-1
Fig 9-2
Cap
Brass Tab-1
Connector
Rail Support
Brass Tab-2
Ground Tab
Rail Support
Ceiling
Knob
Ground Tab
Brass tab-2
Brass tab-1
Screw Driver
Brass Clip-1
Brass Clip-3
Brass Clip-2
Plastic
screw
Plastic
screw
Flexible
Track
Cap
Cap
Ground Tab
Brass Tab-2
Brass Tab-1
The main part
of rail support
Point to Ceiling
Fig. 4
9. Tighten the headless screws completely when all rail supports are installed.
(See Fig 3)
Cap
Connector
Cap
Brass Clip-2
Brass Clip-3
Wire
Plastic screw
Brass Clip-1
Fig. 6
3. Attach the flexible track onto any of the two rail supports on the side of the
canopy.
NOTE: a: The ground tab of the flexible track must point to the ceiling.
b: The brass tab-1 on the flexible track must face you as shown
in Fig 4 and Fig 5).
--- Unscrew the both caps from the rail support and then separate it.
--- Attach the flexible track onto the slot of the main part of the rail support.
--- Put both halves of the rail support back together and screw the caps
back to the rail support tightly.
CB31455 / C0009 --- Page 2
120206