Installation Guide

Fig.1
Screw
Key Hole Slot
1. Attach the two long screws to the holes on
the mounting strap, and screw in 2 to 3 turns.
2. Attach the mounting strap to the outlet box
using two short mounting screws.
3. Pull out the outlet wires and the house
grounding wire from the outlet box. Make wire
connections using the wire nuts:
---The black wire from the fixture to the black wire from the power source.
---The white wire from the fixture to the white wire from the power source.
---Attach the fixture grounding wire to the mounting strap with the green grounding
screw. Then connect it to the house grounding wire with the wire nut.
Carefully put the wires back into the outlet box.
4. Attach the ceiling pan to the mounting strap by inserting two long screw heads into
the key holes, and rotate the pan until it locks in place. Then secure the screws
tightly. (See Fig.1)
5. Screw the nipple into the coupling, then secure it with a hex nut.
6. Install bulbs (not included). See relamping label at socket area or packaging for
maximum allowed wattage.
7. Attach the glass shade to the pan by inserting the nipple, then secure it with a
rubber pad, metal pad and hex nut.
8. Slip the cover up through the nipple, secure it with a finial.
9. Turn on the power at the main fuse or circuit breaker box.
ASSEMBLY AND INSTALLATION
INSTRUCTIONS
WARNING: BE SURE TO SHUT OFF POWER AT THE MAIN FUSE OR CIRCUIT
BREAKER BOX BEFORE INSTALLING OR SERVICING THIS FIXTURE.
NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ AND SAVE THESE INSTRUCTIONS.
C0011 / C0017
Outlet Box
House Grounding Wire
Wire Nut
Long Screw
Ceiling Pan
Socket
Coupling
Hex Nut
Nipple
Glass Shade
Rubber Pad
Metal Pad
Hex Nut
Cover
Finial
Mounting Strap
Green Grounding Screw
Short Mounting Screw
120310
Bulb Type A Max.60W
(not included)
Contents of Spare Parts:
Assembly Kit
(1 SET)
(4487MM For C0011)
(4488MM For C0017)
Glass Shade
(1 PC)
(9322FO For C0011)
(9323CH For C0017)