Installation Guide

Glass Shade
Finial
Hex Nut
Rubber Pad
Fixture
Antler Set
Hex Nut
Metal Pad
Rubber Pad
Canopy
Ball Nut
Bulb Type A Max.100W
(not included)
House Grounding Wire
Wire Nut
Mounting Strap
Green Grounding Screw
Mounting Screw
Lock Nut
Screw
Fixture Grounding Wire
Outlet Box
1. Thread two screws to the mounting strap, and secure
them with two lock nuts. Adjust the length of the screws
if necessary.
2. Attach the mounting strap to the outlet box by using
two mounting screws.
3. Pull out the outlet wires and the house grounding wire
from the outlet box. Make wire connections using
the wire nuts:
---The black wire from the fixture to the black wire
from the power source.
---The white wire from the fixture to the white wire
from the power source.
---Attach the fixture grounding wire to the mounting
strap with the green grounding screw. Then
connect it to the house grounding wire with a
wire nut.
Carefully put the wires back into the outlet box.
4. Attach the canopy to the mounting strap by inserting
the screws, and then secure them with ball nuts.
5. Install bulbs (not included). See relamping label at
socket area or packaging for maximum allowed wattage.
6. Attach the rubber pad and glass shade upward to the fixture, then secure them with a rubber pad,
metal pad and hex nut.
7. Attach the antler set upward to the glass shade carefully by inserting the nipple, and then secure
it with a hex nut and finial.
8. Turn on the power at the main fuse or circuit breaker box.
ASSEMBLY AND INSTALLATION
INSTRUCTIONS
WARNING: BE SURE TO SHUT OFF POWER AT THE MAIN FUSE OR CIRCUIT
BREAKER BOX BEFORE INSTALLING OR SERVICING THIS FIXTURE.
NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ AND SAVE THESE INSTRUCTIONS.
C0020
120710
Assembly Kit
(1 SET)
(4552MM)
Contents of Spare Parts:
Glass Shade
(1 PC)
(9351CR)