Installation Guide

ManualsBrandsCascadia ManualsCeiling LightsMonterey 16.5-in Autumn Patina Rustic Incandescent Semi-Flush Mount Light

ASSEMBLY AND INSTALLATION

INSTRUCTIONS

WARNING: BE SURE TO SHUT OFF POWER AT THE MAIN FUSE OR CIRCUIT

BREAKER BOX BEFORE INSTALLING OR SERVICING THIS FIXTURE.

NOTE: 1.

Before installing, consult local electrical codes for wiring and grounding requirements.

2. READ AND SAVE THESE INSTRUCTIONS.

C0044

Parts:

Parts Number (4777MM)

Mounting Plate (A)

Mounting Screw (B)

Green Grounding

Screw (C)

Wire Nut (D)

130611

Lock Nut (E)

Ball Nut (F)

Main Fixture Body

Nipple (I)

Finial (L)

Parts Number (9460S)

Glass Shade(N) (X1)

Coupling

Hex Nut (H)

Assembly Screw (G)

Outlet Box

House Grounding Wire

Wire Nut (D)

Fixture Wire

Fixture Grounding Wire

Mounting Plate (A)

Green Grounding Screw (C)

Mounting Screw (B)

Assembly Screw(G)

Canopy

Lock Nut (E)

Ball Nut (F)

1. Thread two assembly screws through the mounting plate, and secure them with two lock nuts.

Adjust the length of the assembly screws if necessary.

2. Attach the mounting plate to the outlet box by using two mounting screws.

3. Adjust the arms of the fixture according to the drawing of the package.

Important:

a. The arms should be positioned with equal distances between them.

b. The arms should be fixed securely.

4. Screw the nipple into the coupling on the main fixture body, secrure it with hex nut.

5. Slide the tube, small cap and the metal cap(¢55mm) onto the nipple, secrure them with hex nut.

6. Install bulbs(not included). See relamping label at socket area or packaging for maximum allowed

wattage.

Bulb Type A Max.60W

(not included)

Hex Nut (H)

Cover (K)

Small Cap (Ø48mm) (O)

Metal Cap (Ø55mm) (M)

Hex Nut (H)

Glass Shade (N)

Tube (J)

Parts Number (4778AA)

Finial (L)

Cover (K)

Hex Nut (H)

Nipple (I)

Tube (J)

Metal Cap (Ø55mm) (M)

Metal Cap (Ø48mm) (O)

Small Cap (P)

Summary of content (2 pages)

PAGE 1
C0044 ASSEMBLY AND INSTALLATION INSTRUCTIONS WARNING: BE SURE TO SHUT OFF POWER AT THE MAIN FUSE OR CIRCUIT BREAKER BOX BEFORE INSTALLING OR SERVICING THIS FIXTURE. NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements. 2. READ AND SAVE THESE INSTRUCTIONS.
PAGE 2
7. Place the glass shade over the main fixture body, making sure the nipple feeds through its center hole, then secure it with a metal cap(Ø48mm) and hex nut. 8. Slide the cover up to the glass shade, and secure it with finial. 9. Pull out the outlet wires and the house grounding wire from the outlet box. Make wire connections using the wire nuts: ---The black (hot) wire from the fixture to the black (hot) wire from the power source.