Installation Guide

ManualsBrandsCascadia ManualsCeiling LightsPoirot 14.5-in New Bronze Transitional Incandescent Flush Mount Light

Fig.1

Screw

Key Hole Slot

1. Attach the two long screws to the holes on

the mounting strap, and screw in 2 to 3 turns.

2. Attach the mounting strap to the outlet box

using two short mounting screws.

3. Pull out the outlet wires and the house

grounding wire from the outlet box. Make wire

connections using the wire nuts:

---The black wire from the fixture to the black

wire from the power source.

---The white wire from the fixture to the white

wire from the power source.

---Attach the fixture grounding wire to the mounting

strap with the green grounding screw. Then connect

it to the house grounding wire with the wire nut.

Carefully put the wires back into the outlet box.

ASSEMBLY AND INSTALLATION

INSTRUCTIONS

WARNING: BE SURE TO SHUT OFF POWER AT THE MAIN FUSE OR CIRCUIT

BREAKER BOX BEFORE INSTALLING OR SERVICING THIS FIXTURE.

NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.

2. READ AND SAVE THESE INSTRUCTIONS.

C0064

Outlet Box

House Grounding Wire

Wire Nut(E)

Long Screw(D)

Ceiling Pan

Socket

Coupling

Hex Nut(H)

Nipple(J)

Glass Shade(M)

Rubber Pad(K)

Metal Pad(L)

Hex Nut(H)

Cover(G)

Finial(F)

Mounting Strap(A)

Green Grounding Screw(C)

Short Mounting Screw(B)

Bulb Type A Max.60W

(not included)

Hex Nut (H)

Washer (I)

Nipple (J)

Parts:

Parts Number (4908MM)

Parts Number (9544EW)

Short Mounting Screw (B)

Green Grounding

Screw (C)

Wire Nut (E)

Glass Shade (M) (X1)

Mounting Strap (A)

Long

Screw (D)

Rubber Pad (K)

Metal Pad (L)

Cover (G)

Finial (F)

Washer (I)

131218

Summary of content (2 pages)

PAGE 1
ASSEMBLY AND INSTALLATION INSTRUCTIONS C0064 WARNING: BE SURE TO SHUT OFF POWER AT THE MAIN FUSE OR CIRCUIT BREAKER BOX BEFORE INSTALLING OR SERVICING THIS FIXTURE. NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements. 2. READ AND SAVE THESE INSTRUCTIONS.
PAGE 2
4. Attach the ceiling pan to the mounting strap by inserting two long screw heads into the key holes, and rotate the pan until it locks in place. Then secure the screws tightly. (See Fig.1) 5. Screw the nipple into the coupling, then secure it with a washer and hex nut. 6. Install bulbs (not included). See relamping label at socket area or packaging for maximum allowed wattage. 7. Attach the glass shade to the pan by inserting the nipple, then secure it with a rubber pad, metal pad and hex nut. 8.