Installation Guide

Spare Parts List:
Assembly Kit
5056MM For C0074
5057MM For C0075
(1 SET)
Glass Shade
9598AL
(1 PC)
This fixture is dimmable with a forward phase electronic dimmer. Dimmers tested to be compatible with this
fixture are the Lutron: S-603PG, DVCL-153P, TGCL-153P.
If you are unfamiliar with electrical installations, it is recommended you have a qualified electrician for your
installations.
The following parts are available for re-order if damaged or missing.
4. Attach the ceiling pan to the mounting strap by inserting two long screw heads into the key holes. Rotate the ceiling
pan until it is locked into place. Then tighten the long screws to secure it. (See Fig.1)
Caution: To prevent electrostatic discharge (ESD) damage to the module electronics, do not touch the LED
module on the ceiling pan.
5. Screw the threaded pipe into the coupling, then secure it with a washer and hex nut.
NOTE: Depth of threaded pipe may need to be adjusted to properly fit shade, decorative cup, and finial.
6. Attach the glass shade to the ceiling pan: Inserting the threaded pipe through the hole in the glass shade, then secure
using rubber pad, metal pad and hex nut. Finally, attach the decorative cup to end of threaded pipe using finial to secure.
Turn on the power at the main fuse or circuit breaker box.
140825
Mounting Strap (A)
Mounting Screw (B)
Wire Nut (C)
Green Grounding Screw (D)
Long Screw (E)
Hex Nut (F)
Washer (G)
Threaded Pipe (H)
Finial (L)
Metal Pad (J)
Decorative Cup (K)
Rubber Pad (I)