Installation Guide

ManualsBrandsCascadia ManualsCeiling LightsLED Flush Mount 11-in Vintage Bronze Transitional LED Flush Mount Light

Fig.1

1. Attach the two long screws to the holes on the mounting

strap. Thread them in part way: 2 to 3 turns only.

2. Attach the mounting strap to the outlet box by using

two mounting screws.

3. Pull out the source wires from the outlet box. Make wire

connections using wire nuts as follows:

---Connect the black wire from the fixture to the black

wire from the power source.

---Connect the white wire from the fixture to the white

wire from the power source.

---Attach the fixture grounding wire to the mounting

strap with the green grounding screw. Then

connect it to the house grounding wire with the wire

nut.

Carefully put the wires back into the outlet box.

Long Screw

Key Hole Slot

ASSEMBLY AND INSTALLATION

INSTRUCTIONS

NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.

2. READ AND SAVE THESE INSTRUCTIONS.

C0074 / C0075

Hardware Package (included):

LED module

Coupling

Hex Nut (F)

Threaded Pipe (H)

Hex Nut (F)

Finial (L)

Glass Shade

Washer (G)

Outlet Box

House Grounding Wire

Wire Nut (C)

Long Screw (E)

Ceiling Pan

Mounting Strap (A)

Green Grounding Screw (D)

Mounting Screw (B)

Metal Pad (J)

Decorative Cup (K)

Rubber Pad (I)

Warning: LED electronics can be damaged by electro static discharge (ESD)shock. Before

installation, discharge yourself by touching a grounded bare metal surface to remove this

hazard. To avoid damage, do not touch the LED module.

WARNING:

TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF

POWER WHILE INSTALLING OR SERVICING THIS FIXTURE.

Turn off the power at fuse or circuit box.

Mounting Strap (A)

Mounting Screw (B)

Wire Nut (C)

Green Grounding Screw (D)

Long Screw (E)

Hex Nut (F)

Washer (G)

Threaded Pipe (H)

Finial (L)

Metal Pad (J)

Decorative Cup (K)

Rubber Pad (I)

140825

Summary of content (2 pages)

PAGE 1
ASSEMBLY AND INSTALLATION INSTRUCTIONS C0074 / C0075 WARNING: TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF POWER WHILE INSTALLING OR SERVICING THIS FIXTURE. NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements. 2. READ AND SAVE THESE INSTRUCTIONS. Warning: LED electronics can be damaged by electro static discharge (ESD)shock. Before installation, discharge yourself by touching a grounded bare metal surface to remove this hazard.
PAGE 2
4. Attach the ceiling pan to the mounting strap by inserting two long screw heads into the key holes. Rotate the ceiling pan until it is locked into place. Then tighten the long screws to secure it. (See Fig.1) Caution: To prevent electrostatic discharge (ESD) damage to the module electronics, do not touch the LED module on the ceiling pan. 5. Screw the threaded pipe into the coupling, then secure it with a washer and hex nut.