Installation Guide

ManualsBrandsCascadia ManualsCeiling LightsAvenant 18-in French Bronze Traditional Incandescent Semi-flush Mount Light

Thread the long screws through mounting strap, then secure them

with two lock nuts. Adjust the length of long screws if necessary.

2. Attach the mounting strap to the outlet box by using two mounting screws.

Pull out the source wires from the outlet box. Make wire connections using wire nuts as follows:

---Connect the hot wire (usually black insulation) from the fixture to the black wire from the power source.

---Connect the neutral wire (usually white insulation) from the fixture to the white wire from the power source.

---Attach the fixture grounding wire (usually bare wire) to the mounting strap with the green grounding screw, then connect

it to the house grounding wire with a wire nut. If your outlet box does not have a house grounding wire, then wrap the

fixture grounding wire around the green grounding screw.

Carefully tuck the wires back into the outlet box.

4. Attach the fixture to the mounting strap, and secure it with two ball nuts.

5. Attach threaded pipe to the coupling of the socket, and secure it with a washer and hex nut.

NOTE:Depth of threaded pipe may need to be adjusted to properly fit glass shade, decorative cup and finial.

6. Install bulbs (not included). See relamping label at socket area or packaging for maximum allowed wattage.

7. Attach the glass shade to the ceiling pan by inserting the threaded pipe, then secure it

with a metal pad, rubber pad and hex nut.

Ball Nut (G)

Fixture

Bulb Type A Max.100W

(not included)

Hex Nut (I)

Washer (J)

Threaded Pipe (K)

Hardware Package (included):

Socket

Coupling

Hex Nut(I)

Washer(J)

Threaded Pipe(K)

Glass Shade

Decorative Cup (N)

Finial (H)

ASSEMBLY AND INSTALLATION

INSTRUCTIONS

NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.

2. READ AND SAVE THESE INSTRUCTIONS.

C0080

150117

Mounting Screw (B)

Green Grounding

Screw (C)

Wire Nut (F)

Lock Nut (E)

Mounting Strap (A)

Long Screw (D)

Ball Nut (G)

Rubber Pad (L)

Metal Pad (M)

Decorative Cup (N)

Finial (H)

Hex Nut(I)

Metal Pad (M)

Rubber Pad (L)

WARNING:

TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF

POWER WHILE INSTALLING OR SERVICING THIS FIXTURE.

Turn off the power at fuse or circuit box.

Installation Steps

Outlet Box

House Grounding Wire

Wire Nut (F)

Long Screw (D)

Mounting Strap (A)

Lock Nut (E)

Green Grounding Screw (C)

Mounting Screw (B)