Manualshelf

Installation Guide

ManualsBrandsCascadia ManualsFlush Mount LightingApollo 14.5-in Bronze Transitional Led Flush Mount Light
12
ASSEMBLY AND INSTALLATION
INSTRUCTIONS
NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ AND SAVE THESE INSTRUCTIONS.
C0087
Hardware Package (included):
Warning: LED electronics can be damaged by electro static discharge (ESD)shock. Before
installation, discharge yourself by touching a grounded bare metal surface to remove this
hazard. To avoid damage, do not touch the LED module.
WARNING:
TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF
POWER WHILE INSTALLING OR SERVICING THIS FIXTURE.
Turn off the power at fuse or circuit box
141023
Mounting Strap (A)
Green Grounding
Screw (C)
Long Screw(E)
Ball Nut(G)
Mounting Screw (B)
Wire Nut (D)
Lock Nut (F)
Outlet Box
House Grounding Wire
Wire Nut (D)
Long Screw (E)
Ceiling Pan
Mounting Strap (A)
Green Grounding Screw (C)
Mounting Screw (B)
Plastic Shade
Lock Nut (F)
LED Module
Ball Nut(G)
1. Remove the plastic shade from the ceiling pan.
2. Attach the mounting strap to the outlet box
by using two mounting screws.
3. Pull out the source wires from the outlet box.
Make wire connections using wire nuts as
follows:
---Connect the hot wire (usually black insulation)
from the fixture to the black wire from the
power source.
---Connect the neutral wire (usually white
insulation) from the fixture to the white wire
from the power source.
---Attach the fixture grounding wire (usually
green insulation or bare wire) to the mounting
strap with the green grounding screw. Then
connect it to the house grounding wire with
the wire nut.
Carefully put the wires back into the outlet box.
4. Attach the ceiling pan to the mounting strap by inserting two long screws into the holes, then tighten the ceiling pan
by screwing the ball nuts into the long screws.
Caution: To prevent electrostatic discharge (ESD) damage to the module electronics, do not touch the LED
module on the ceiling pan.
5. Attach the plastic shade back to the ceiling pan, rotate the plastic shade clockwise until it is locked in place.
Turn on the power at fuse or circuit box.
Installation Steps

Summary of content (2 pages)