Installation Guide

ASSEMBLY AND INSTALLATION
INSTRUCTIONS
NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ AND SAVE THESE INSTRUCTIONS.
C0098
Hardware Package (included):
WARNING:
TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF
POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.
Turn off the power at fuse or circuit box
150618
Mounting Strap (A)
Green Grounding
Screw (C)
Long Screw(D)
Mounting Screw (B)
Wire Nut (E)
Turn on the power at fuse or circuit box
Outlet Box
House Grounding Wire
Wire Nut(E)
Long Screw(D)
Ceiling Pan
Socket
Stud
Slot
Glass Shade
Mounting Strap(A)
Green Grounding Screw(C)
Mounting Screw(B)
Fig.1
Long Screw
Key Hole Slot
Installation Steps
Bulb Type A Max.60W
(not included)
1. Attach the two long screws to the holes on the mounting
strap. Thread them in part way: 2 to 3 turns only.
2. Attach the mounting strap to the outlet box using two mounting
screws.
3. Pull out the source wires from the outlet box. Make wire
connections using wire nuts as follows:
---Connect the hot wire (usually black insulation) from the
fixture to the black wire from the power source.
---Connect the neutral wire (usually white insulation) from
the fixture to the white wire from the power source.
---Attach the fixture grounding wire (usually green insulation or bare wire) to the mounting strap with the green
grounding screw, and then connect them to the house grounding wire with the wire nut.
Carefully put the wires back into the outlet box.
4. Attach the ceiling pan to the mounting strap by inserting two long screw heads into the key holes. Rotate the ceiling
pan until it is locked into place, and then tighten the long screws to secure it. (See Fig.1)
5. Install two bulbs (not included). Check relamping label at socket area or packaging for maximum allowed wattage.
6. Attach the glass shade to the ceiling pan by aligning studs and slots, and turn it clockwise until it locks in place.
Caution: Do not over tighten.