Installation Guide

ASSEMBLY AND INSTALLATION
INSTRUCTIONS
NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ AND SAVE THESE INSTRUCTIONS.
C0114
Hardware Package (included):
WARNING:
TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF
POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.
Turn off the power at fuse or circuit box
151208
Green Grounding
Screw (E)
Fixture Mounting
Screw(D)
Mounting Screw (B)
Wire Nut (C)
Installation Steps
Lock Nut (F)
Ball Nut (G)
Canopy
Ball Nut (G)
Threaded Pipe
Outlet Box
House Grounding Wire
Wire Nut(C)
Fixture Mounting Screw (D)
Mounting Strap(A)
Green Grounding Screw(E)
Lock Nut(F)
Mounting Screw(B)
Mounting Strap (A)
Bulb Type A Max.60W
(not included)
Socket
Coupling
Tube
Hex Nut (I)
Long Threaded Pipe (H)
Decorative Cup (J)
Finial (K)
Plastic Plate
Frosting
Bracket
Fabric Shade
Hex Nut (I)
Long Threaded Pipe (H)
Decorative Cup (J)
Finial (K)
1. Thread the fixture mounting screws through mounting strap,
and then secure them with two lock nuts. Adjust the length
of fixture mounting screws if necessary.
2. Attach mounting strap to the outlet box using two mounting
screws.
3. Thread the fixture wire through the tube and the canopy.
4. Attach one end of the tube to the canopy, and the other end to the
threaded pipe of the fixture.
5. Attach the long threaded pipe to coupling.
6. Slip the plastic plate and decorative cup up
through the long threaded pipe, and then
secure them with the finial.
NOTE: The depth of hex nut in long
threaded pipe may need to be adjusted to
properly fit the plastic plate. The plastic
plate should be flatly laid on three brackets,
and the frosting of the plastic plate should
be faced down.
7. Install bulbs (not included). Check relamping
label at socket area or packaging for maximum
allowed wattage.
8. Pull out the source wires from the outlet box. Make wire connections using wire nuts as follows:
---Connect the hot wire (usually black insulation) from the fixture to the black wire from the power source.
---Connect the neutral wire (usually white insulation) from the fixture to the white wire from the power source.
---Attach the fixture grounding wire (usually green insulation or bare wire) to the mounting strap with the green
grounding screw, and then connect it to the house grounding wire with the wire nut.
Carefully put the wires back into the outlet box.