Installation Guide

160926
Turn on the power at fuse or circuit box
6. Connect the chain:
- Determine length of chain needed to achieve desired fixture height. (To remove excess chain section,
use pliers to bend link open.)
- Weave the fixture wires and fixture grounding wire through the chain, collar and canopy.
7. Connect one end of the chain to the loop using a loop lock.
8. Connect the other end of the chain to top loop by using the other loop lock.
9.Thread the fixture wire and fixture grounding wire through the top loop, threaded pipe and mounting strap.
10. Cut the redundant wires if necessary. Pull out the source wires from the outlet box. Make wire connections using wire
nuts as follows:
---Connect the smooth-coated wire (marked) from the fixture to the black wire from the power source.
---Connect the ribbed-coated wire (unmarked) from the fixture to the white wire from the power source.
---Attach the fixture grounding wire to the mounting strap with the green grounding screw, and then connect it to the
house grounding wire with a wire nut.
Carefully put the wires back into the outlet box.
11. Attach the canopy to the mounting strap by inserting the top loop, and then secure it with the collar.
12. Adjust the three arms and allow the angel between them is the same.
13. Install three bulbs (not included). Check relamping label at socket area or packaging for maximum allowed wattage.
14. Attach the threaded pipe into the coupling of socket, and secure it with the washer and hex nut.
Note: Depth of the threaded pipe may need to be adjusted to properly fit glass shade,decorative cup and finial.
15. Attach the tube onto the tube cover above the coupling and another tube cover and cap onto the bottom of the tube.
Then tighten them with the hex nut. Make sure the opening side of cap facing down.
16. Slip the glass shade and metal pad through the threaded pipe and upward the socket base. Then tighten them with the
hex nut.
Caution: Do not over tighten, breakage of glass shade could be occurred.
17. Slip the the decorative cup up through the threaded pipe, secure it with a finial.
For Semi-Flush
Hardware Package (included):
Turn off the power at fuse or circuit box
Mounting Strap (A)
Green Grounding
Screw (E)
Fixture Mounting
Screw(D)
Mounting Screw (B)
Wire Nut (C)
Lock Nut (F)
Ball Nut (G)
Outlet Box
House Grounding Wire
Wire Nut(C)
Fixture Mounting Screw (D)
Mounting Strap(A)
Green Grounding Screw(E)
Canopy
Ball Nut (G)
Lock Nut(F)
Mounting Screw(B)
1. Remove contents of hardware package marked
“For Semi-Flush”.
2. Attach two fixture mounting screws to the mounting
strap, and then secure it with two lock nuts. Adjust
the length of the fixture mounting screws if necessary.
3. Attach the mounting strap to the outlet box using two
mounting screws.
4. Cut the redundant wires if necessary. Pull out the source
wires from the outlet box. Make wire connections using
wire nuts as follows:
---Connect the smooth-coated wire (marked) from the fixture to the black wire from the power source.
---Connect the ribbed-coated wire (unmarked) from the fixture to the white wire from the power source.
---Attach the fixture grounding wire to the mounting strap with the green grounding screw, and then connect it to the
house grounding wire with a wire nut.
Carefully put the wires back into the outlet box.
5. Unscrew the ball nut from the canopy. Attach the canopy to the mounting strap by inserting the fixture mounting screws,
and then secure it with two ball nuts.
6. Follow steps 12~17 of instructions For Semi-Flush.
Turn on the power at fuse or circuit box