Installation Guide

ManualsBrandsCascadia ManualsFlush Mount LightingToledo 13-in Satin Nickel industrial incandescent Flush Mount Light

Fig.1

Screw

Key Hole Slot

1. Attach the two fixture mounting screws to the holes

on the mounting strap, and screw them in 2 to

3 turns.

2. Attach the mounting strap to the outlet box

using two mounting screws.

ASSEMBLY AND INSTALLATION

INSTRUCTIONS

NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.

2. READ AND SAVE THESE INSTRUCTIONS.

C0134

Outlet Box

House Grounding Wire

Wire Nut(E)

Fixture Mounting Screw(D)

Ceiling Pan

Socket

Coupling

Tube (I)

Glass Shade

Metal Pad(J)

Nipple (H)

Threaded Pipe

Hex Nut(K)

Cover(G)

Finial(F)

Mounting Strap(A)

Green Grounding Screw(C)

Mounting Screw(B)

Bulb Type A Max.60W

(not included)

Nipple (H)

Tube W/Threaded Pipe (I)

Hardware Package (included):

Mounting Screw (B)

Green Grounding

Screw (C)

Wire Nut (E)

Mounting Strap (A)

Fixture

Mounting Screw (D)

Metal Pad (J)

Hex Nut (K)

Cover (G)

Finial (F)

161010

WARNING:

TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF

POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.

3.Pull out the source wires from the outlet box.

Make wire connections using wire nuts as follows:

---Connect the hot wire (usually black insulation)

from the fixture to the black wire from the power

source.

---Connect the neutral wire (usually white insulation)

from the fixture to the white wire from the power

source.

---Attach the fixture grounding wire (usually green

insulation or bare wire) to the mounting strap with

the green grounding screw, and then connect it

to the house grounding wire with the wire nut.

Carefully put the wires back into the outlet box.

Turn off the power at fuse or circuit box

Installation Steps

Summary of content (2 pages)

PAGE 1
ASSEMBLY AND INSTALLATION INSTRUCTIONS C0134 WARNING: TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE. NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements. 2. READ AND SAVE THESE INSTRUCTIONS.
PAGE 2
4. Attach the ceiling pan to the mounting strap by inserting two fixture mounting screw heads into the key holes, and rotate the pan until it locks in place. Then secure the screws tightly. (See Fig.1) 5. Screw the tube with the threaded pipe head into the coupling until tightened. 6. Install bulbs (not included). See relamping label at socket area or packaging for maximum allowed wattage. 7. Secure the nipple into the tube. Adjust the nipple to the suitable location.