Installation Guide

Turn off the power at fuse or circuit box
170105
Installation Steps
Turn on the power at fuse or circuit box
Outlet Box
House Grounding Wire
Wire Nut(E)
Fixture Mounting Screw(D)
Ceiling Pan
Coupling
Hex Nut(J)
Threaded
pipe(H)
Mounting Strap(A)
Green Grounding Screw(C)
Mounting Screw(B)
Washer (G)
Bulb Type A Max.60W
(not included)
Glass Shade
Plastic Washer (I)
Hex Nut (J)
Washer (G)
Finial(F)
1. Attach the two fixture mounting screws to
the holes on the mounting strap, and screw
them in 2 to 3 turns.
2. Attach the mounting strap to the outlet box
using two mounting screws.
3. Pull out the source wires from the outlet
box.
Make wire connections using wire nuts as
follows:
---Connect the black wire from the fixture
to the black wire from the power source.
---Connect the white wire from the fixture to
the white wire from the power source.
---Attach the fixture grounding wire to the
mounting strap with the green grounding
screw. Then connect it to the house
grounding wire with the wire nut.
Carefully put the wires back into the outlet
box.
4. Attach the ceiling pan to the mounting strap
by inserting two fixture mounting screw
heads into the key holes , and rotate the pan
until it locks in place, and then secure the
screws tightly. (See Fig.7)
5. Screw the threaded pipe into the coupling,
then secure it with a washer and hex nut.
Note: Depth of threaded pipe may need to
be adjusted to properly fit glass shade, plastic
washer, washer, hex nut and finial.
6. Install bulbs (not included). See relamping
label at socket area or packaging for maximum
allowed wattage.
7. Attach the glass shade to the fixture by inserting the threaded pipe, then secure it with a washer
and hex nut, and then tighten the finial to the threaded pipe.
Fig.7
Screw
Key Hole Slot