Installation Guide

ManualsBrandsCascadia ManualsCeiling LightsCarlisle 13.5-in Noble Bronze Transitional Incandescent Semi-flush Mount Light

ASSEMBLY AND INSTALLATION

INSTRUCTIONS

NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.

2. READ AND SAVE THESE INSTRUCTIONS.

C0143

Hardware Package (included):

WARNING:

TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF

POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.

Turn off the power at fuse or circuit box

170224

Mounting Strap (A)

Green Grounding

Screw (E)

Fixture Mounting

Screw(D)

Mounting Screw (B)

Wire Nut (C)

Installation Steps

Lock Nut (F)

Ball Nut (G)

Fixture Canopy

Ball Nut (G)

Washer

Hex Nut

Metal Pad

Hex Nut

Pan

Hex Nut

Long Nipple

Short Nipple

Glass Shade

Coupling

Outlet Box

House Grounding Wire

Wire Nut (C)

Fixture Mounting Screw (D)

Mounting Strap (A)

Green Grounding Screw (E)

Lock Nut (F)

Mounting Screw (B)

Bulb Type A Max.100W

(not included)

Socket

Hex Nut

Washer

Glass Panel with

Ring

Metal Pad

Cover

Finial

Cap

Pipe Assembly

1. Attach two fixture mounting screws to mounting

strap, and then secure it with two lock nuts. Adjust

the length of the fixture mounting screws if

necessary.

2. Attach the mounting strap to outlet box using two

mounting screws.

3. Thread the fixture wire and fixture grounding wire

through the long nipple, pipe assembly, cap, fixture

canopy, metal pad, washer and hex nut.

4. Screw the long nipple into the coupling on the top of

the pan

and secure

the preinstalled washer and

hex nut.

5. Slip the pipe assembly, the cap and fixture canopy

down through the long nipple, finally secure them

with the metal pad, the washer and the hex nut.

6. Pull out the source wires from the outlet box. Make

wire connections using wire nuts as follows:

---Connect the hot wire (usually black insulation) from

the fixture to the black wire from the power source.

---Connect the neutral wire (usually white insulation)

from the fixture to the white wire from the power

source.

---Attach the fixture grounding wire (usually green

insulation or bare wire) to the mounting strap with

the green grounding screw, and then connect it to

the house grounding wire with the wire nut.

Carefully put the wires back into the outlet box.

Summary of content (2 pages)

PAGE 1
C0143 ASSEMBLY AND INSTALLATION INSTRUCTIONS WARNING: TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE. NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements. 2. READ AND SAVE THESE INSTRUCTIONS.
PAGE 2
7. Attach the fixture canopy to the mounting strap, and then secure it with the ball nuts. 8. Install three bulbs (not included). See relamping label at socket area or packaging for maximum allowed wattage. 9. Screw the short nipple to the coupling of the socket base and secure the preinstalled washer and hex nut. 10. Attach the glass shade and glass panel with ring up to the pan by inserting the short nipple, and then secure them with a metal pad and a hex nut (Do not over tighten). 11.