Installation Guide

ASSEMBLY AND INSTALLATION
INSTRUCTIONS
NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ AND SAVE THESE INSTRUCTIONS.
C0159
WARNING:
TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF
POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.
Turn off the power at fuse or circuit box.
Installation Steps
Warning: LED electronics can be damaged by electro static discharge (ESD)shock. Before
installation, discharge yourself by touching a grounded bare metal surface to remove this
hazard. To avoid damage, do not touch the LED module.
Mounting Screw (B)
Green Grounding Screw (C)
Wire Connector (D)
House Grounding Wire
Fixture Grounding Wire
Outlet Box
Fixture Wire
Threaded Pipe(E)
Mounting Strap (A)
Hex Nut (F)
Ceiling Pan
LED Cover
Slot
Plastic Shade
End Cap(H)
Rubber Pad(G)
Hardware Package (included):
Mounting Screw (B)
Threaded Pipe (E)
Green Grounding
Screw (C)
Wire Connector (D)
Mounting Strap (A)
Hex Nut (F)
Rubber Pad(G)
End Cap(H)
Stud
171211
1. Remove the plastic shade from the ceiling pan.
2. Attach the mounting strap to the outlet box
by using two mounting screws.
3. Pull out the source wires from the outlet box.
Make wire connections using wire connectors as follows:
---Connect the hot wire (usually black insulation)
from the fixture to the black wire from the
power source.
---Connect the neutral wire (usually white
insulation) from the fixture to the white wire
from the power source.
---Attach the fixture grounding wire (usually
green insulation or bare wire) to the mounting
strap with the green grounding screw. Then
connect it to the house grounding wire with
the wire connectors.
Carefully put the wires back into the outlet box.
4. Attach the ceiling pan to the mounting strap by inserting threaded pipe into the center hole of the ceiling pan, and
then secure it with rubber pad and end cap.
5. Attach the plastic shade back to the ceiling pan, rotate the plastic shade clockwise until it is locked in place.
Turn on the power at fuse or circuit box.