Installation Guide

Pan
Socket
Coupling
Washer
Hex Nut
Nipple
Hex Nut
Cap
Finial
Metal Pad
Glass Shade
Wire Connector
House Grounding Wire
Outlet Box
Mounting Strap
Green Grounding Screw
Mounting Screw
Screw
Fixture Grounding Wire
Fig.1
Screw
Key Hole Slot
1. Attach the two screws to the mounting strap.
2. Attach the mounting strap to the outlet box by using two mounting screws.
3. Pull out the outlet wires and the house grounding wire from the outlet box. Make wire
connections using the wire connectors:
---The black wire from the fixture to the black wire from the power source.
---The white wire from the fixture to the white wire from the power source.
---Attach the fixture grounding wire to the mounting strap with the green grounding screw.
Then connect it to the house grounding wire with the wire connector.
Carefully put the wires back into the outlet box.
4. Attach the pan to the mounting strap by inserting two screws and rotate the pan until it
locks in place. Then secure the screws tightly.
5. Screw the nipple into the coupling, then secure it with a washer and hex nut.
6. Install bulbs (not included). See relamping label at socket area or packaging for maximum
allowed wattage.
7. Attach the glass shade to the pan by inserting the nipple, then secure it with a metal pad
and hex nut. Then carefully attach the cap to the glass shade and secure it with the finial.
8. Turn on the power at the main fuse or circuit breaker box.
ASSEMBLY AND INSTALLATION
INSTRUCTIONS
WARNING: BE SURE TO SHUT OFF POWER AT THE MAIN FUSE OR CIRCUIT
BREAKER BOX BEFORE INSTALLING OR SERVICING THIS FIXTURE.
NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. Read and save these instructions.
C0180
171023