Installation Guide

Fig.1
Screw
Keyhole Slot
ASSEMBLY AND INSTALLATION
INSTRUCTIONS
WARNING: BE SURE TO SHUT OFF POWER AT THE MAIN FUSE OR CIRCUIT
BREAKER BOX BEFORE INSTALLING OR SERVICING THIS FIXTURE.
NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ AND SAVE THIS INSTRUCTIONS.
C0181
House Grounding Wire
Outlet Box
Wire Nut
Mounting Strap
Green Grounding Screw
Mounting Screw
Screw
Fixture Wire
Fixture Grounding Wire
Ceiling Pan
Socket
Coupling
Washer
Hex Nut
Glass Shade
Metal Pad
Hex Nut
Cover
Finial
1. Attach two screws to the mounting strap, and screw in 2 to 3 turns.
2. Attach the mounting strap to the outlet box using two mounting screws.
3. Pull out the outlet wires and the house grounding wire from the outlet box. Make wire connections
using the wire nuts:
---The black wire from the fixture to the black wire from the power source.
---The white wire from the fixture to the white wire from the power source.
---Attach the fixture grounding wire to the mounting strap with the green grounding screw. Then
connect it to the house grounding wire with the wire nut.
Carefully put the wires back into the outlet box.
4. Attach the ceiling pan to the mounting strap by inserting two screw heads into the key holes,
and rotate the ceiling pan until it locks in place. Then secure the screws tightly. (See Fig.1)
5. Screw the threaded pipe into the coupling, then secure it with a washer and hex nut.
6. Install bulbs (not included). See relamping label at socket area or packaging for maximum allowed
wattage.
7. Attach the glass shade to the ceiling pan by inserting the threaded pipe, then secure it with a metal
pad and hex nut. Then slide the cover up to the glass shade, and secure it with the finial.
8. Turn on the power at the main fuse or circuit breaker box.
171016
Threaded Pipe
Bulb Type A Max.60W
(not included)