Installation Guide

ManualsBrandsCascadia ManualsCeiling LightsIsley 15-in Satin Nickel Transitional Incandescent Flush Mount Light

C0199

POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.

2. READ AND SAVE THESE INSTRUCTIONS.

Mounting Strap(A) Fixture Mounting Green Grounding Mounting Screw (D) Wire Connector (E) Ball Nut (F) Lock Nut (G)

Screw (B) Screw (C)

Nipple (H)

Installation Steps

1. Attach the two screws to the

mounting strap.

2. Attach the mounting strap to the

outlet box by using two mounting screws.

3. Pull out the outlex wires and the

house grounding wire from the outlex

box. Make wire connections using

the wire connector:

---Connect the hot wire (usually black

insulation) from the fixture to the black

wire from the power source.

---Connect the neutral wire (usually

white insulation) from the fixture to the

white wire from the power source.

20181108

Turn off the power at fuse or circuit box

Metal Pad (I)

Hex Nut (J)

Cap (K)

ASSEMBLY AND INSTALLATION

INSTRUCTIONS

WARNING:

NOTES: 1. Before installing, consult local electrical codeds for wiring and grounding requirements.

Hardware Package (included):

TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF

Outlet Box

Mounting Screw(D)

Green Grounding

Screw(C)

Mounting Strap (A)

Glass Shade

Hex Nut (J)

Bulb Type ST / A Max.

60W (not included)

Nipple

Coupling

Ball Nut (F)

Wire Connector (E)

Cap (K)

Lock Nut (G)

House Grounding Wire

Fixture Grounding Wire

Fixture Mounting Screw

Metal Pad (I)

Pan

Socket

Summary of content (2 pages)

PAGE 1
ASSEMBLY AND INSTALLATION INSTRUCTIONS C0199 WARNING: TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE. NOTES: 1. Before installing, consult local electrical codeds for wiring and grounding requirements. 2. READ AND SAVE THESE INSTRUCTIONS.
PAGE 2
---Attach the fixture grounding wire (usually green insulation or bare wire) to the mounting plate with the green grounding screw, and then connect it to the house grounding wire with the wire connector. Carefully put the wires back into the outlet box. 4. Attach the pan to the mounting strap by inserting two ball nuts and rotate the pan until it locks in place. Then secure the ball nuts tightly. 5. Screw the nipple into the coupling and secure it tightly. 6. Install bulbs (not included).