Installation Guide

ASSEMBLY AND INSTALLATION
INSTRUCTIONS
181115
NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ AND SAVE THESE INSTRUCTIONS.
C0207
WARNING:
TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF
POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.
Hardware Package (included):
Mounting Strap (A)
Mounting Screw (B)
Wire Connector (C)
Cupule (H)
GU10 LED Bulb
Max.7W X3 (I)
Mounting Ball (G)
Hex Nut (D)
Washer (E)
Nipple (F)
House Grounding Wire
Hex Nut (D)
Washer (E)
Wire Connector (C)
Mounting Strap (A)
Mounting Screw (B)
Fixture Grounding Wire
Nipple (F)
Fixture Wire
Outlet Box
House
Grounding Wire
Green Grounding Screw
1. Attach the nipple (F) thread the mounting
strap (A), and then secure it with a washer
(E) and hex nut (D), then tighten them.
2. Attach the mounting strap (A) to the outlet box
by inserting two mounting screws (B) in both
side of mounting strap (A) and tighten them.
3. Pull out the source wires from the outlet box.
Make wire connections using wire connectors (C)
as follows:
--Connect the black (hot) wire from the fixture to
the black (hot) wire from the power source.
---Connect the white (neutral) wire from the fixture
to the white (neutral) wire from the power source.
---Attach the fixture grounding wire to the mounting
strap (A) with the green grounding screw.
Then connect it to the house grounding wire with
a wire connector (C).
Carefully put the wires back into the outlet box.
4. Attach the ceiling pan to the mounting strap (A) by
inserting nipple (F) through the center hole of the
ceiling pan, and then secure it with mounting ball (G).
Turn off the power at fuse or circuit box
Installation Steps
x
Light Head
Mounting Ball (G)
Ceiling Pan
Swivel
GU10 LED Max.7W (I)
(included)
Cupule (H)