Installation Guide

ManualsBrandsCascadia ManualsFixed Track Lighting KitsFulton 1-Light 5-in Bronze Dimmable Standard Flush Mount Fixed Track Light Kit

Cross Bar (A)

Mounting Screw (B) Wire Connector (C)

Canopy

Light Head

Glass Shade (E)

Hand Screw (F)

Swivel

Outlet Box

Set Screw

Mounting Screw (B)

Wire Connector (C)

Cross Bar (A)

Green Grounding Screw

G45 LED Bulb Max.4W (D)

(included)

ASSEMBLY AND INSTALLATION

INSTRUCTIONS

NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.

2. READ AND SAVE THESE INSTRUCTIONS.

C0210

Hardware Package (included):

WARNING:

TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF

POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.

181206

Turn off the power at fuse or circuit box

Turn on the power at fuse or circuit box

Installation Steps

1. Attach the cross bar (A) to the outlet box by using

two mounting screws (B).

2. Pull out the outlet wires and the house grounding

wire from the outlet box. Make wire connections

by using the wire connector (C) as follows.

--- Connect the black (hot) wire from the

fixture to the black (hot) wire from the power source.

--- Connect the white (neutral) wire from the fixture to

the white (neutral) wire from the power source.

--- Attach the fixture grounding wire to the cross

bar (A) with the green grounding screw.

Then connect it to the house grounding wire

with a wire connector (C).

Carefully put the wires back into the outlet box.

3. Attach the canopy to the cross bar (A) by aligning

holes, secure the set screws from the side hole

of the canopy into the hole in the side of the cross bar (A)，

then tighten the screws.

4. Attach the glass shade (E) to the light head, by secure the

hand screws (F) through the holes on the light head to the

glass shade (E), then tighten the screws.

5. Attach the LED bulb (D) into the glass shade (E) and screw

it to the light head, then tighten the bulb (D) in place.

Caution: LED Lamp, Type A or G, E12 base, maximum 25W

Incandescent Lamp, Type A or G, E12 base, maximum 60W

Notes: LED Dimmable bulb to be compatible with most LED Dimmers, recommended Lutron:

MSCL-OP153MH, MACL-153MH, DVWCL-153PH, TGCL-153PH, SCL-153PH.

6. Adjust the light head to a desired position by using the swivel.

G45 LED Bulb Max.4W (D) Glass Shade (E)

Summary of content (2 pages)

PAGE 1
ASSEMBLY AND INSTALLATION INSTRUCTIONS C0210 WARNING: TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE. NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements. 2. READ AND SAVE THESE INSTRUCTIONS. Hardware Package (included): Cross Bar (A) Mounting Screw (B) Installation Steps Wire Connector (C) G45 LED Bulb Max.
PAGE 2
The following parts are available for re-order if damaged or missing. Spare Parts List: Assembly Kit 6066MM (1SET) Cross Bar (A) G45 LED Bulb Max.4W (D) 8105 LED Mounting Screw (B) Glass Shade (E) 10080GS Wire Connector (C) Hand Screw (F) 6071MM 5-YEAR LIMITED WARRANTY: All products are warranted to be free of defects in material and workmanship for five (5) years from date of purchase.