Installation Guide

ASSEMBLY AND INSTALLATION
INSTRUCTIONS
NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ AND SAVE THESE INSTRUCTIONS.
C0217
WARNING:
TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF
POWER WHILE INSTALLING OR SERVICING THIS FIXTURE.
181126
Turn off the power at fuse or circuit box.
Turn on the power at fuse or circuit box.
Installation Steps
1. Screw the fixture rod to the down fixture with nipple tightly.
2. Attach two fixture mounting screws to the mounting strap,
and secure it with two lock nuts. Adjust the length of the
fixture mounting screws if necessary.
3. Attach the mounting strap to the outlet box by using two fixture
mounting screws.
4. Pull out the source wires from the outlex box. Make wire
connections using wire connectors as follows:
---Connect the hot wire (usually black insulation) from
the fixture to the black wire from the power source.
---Connect the neutral wire (usually white insulation) from
the fixture to the white wire from the power source.
---Attach the fixture grounding wire (usually green insulation
or bare wire) to the mounting plate with the green grounding
screw, and then connect it to the house grounding wire with
the wire connector.
Carefully put the wires back into the outlet box.
5. Attach the canopy to the mounting strap, and secure it with the ball nuts.
6. Install bulbs (not included). Check relamping label at socket area or packaging for maximun allowed wattage.
7. Attach the glass shades to the glass holders directly.
Hardware Package (included):
Fixture Mounting screw (E)
Mounting Screw (B) Green Grounding Screw (C)
Wire Connector (D)
Lock Nut (F)
Mounting Strap (A)
Ball Nut (G)
Outlet Box
House Grounding Wire
Fixture Grounding Wire
Fixture Mounting Screw (E)
Lock Nut (F)
Mounting Strap (A)
Green Grounding Screw (C)
Mounting Screw (B)
Canopy
Fixture Rod
Down Fixture
Bulb Type T
Max. 60W
(not included)
Glass Holder
Nipple
Ball Nut (G)
Wire Connector (D)