Installation Guide

ASSEMBLY AND INSTALLATION
INSTRUCTIONS
NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ AND SAVE THIS INSTRUCTION.
190418
C0229
Hardware Package (included):
WARNING:
TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF
POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.
Turn off the power at fuse or circuit box
Installation Steps
1. Thread two fixture mounting screws (D) through the mounting strap (A),
and then secure with two lock nuts (E). Adjust the length of the fixture
mounting screws (D) if necessary .
2. Attach the mounting strap (A) to the outlet box by using two mounting
screws (B).
3. Pull out the source wires from the outlet box. Make wire connections
using wire connectors (C) as follows:
---Connect the hot wire (black insulation) from the fixture to
the black wire from the power source.
---Connect the neutral wire (white insulation) from the fixture
to the white wire from the power source.
---Attach the fixture ground wire (green insulation or bare
wire) to the mounting strap with the green ground screw. Then
connect it to the house ground wire with the wire connector (C).
Carefully put the wires back into the outlet box.
4. Attach the canopy kit to the mounting strap (A) by inserting the
fixture mounting screws (D), and then secure it with two ball nuts (F) .
5. Attach the glass shade to the fixture by threading support
rods onto the glass shade. (Do not over tighten)
6. Install bulb (not included) to the fixture.
Check relamping label at socket area or packaging for
maximum allowed wattage.
Turn on the power at fuse or circuit box
Outlet Box
House Ground Wire
Wire Connector (C)
Mounting Strap (A)
Canopy Kit
Lock Nut (E)
Green Ground Screw
Mounting Screw (B)
Fixture Ground Wire
Fixture Wire
Fixture Mounting Screw (D)
Ball Nut (F)
Glass Shade
Support Rod
Fixture
Bulb Type A Max.100W
(not included)
Mounting Strap (A) Fixture Mounting Screw (D)Wire
Connector (C)
Lock Nut (E) Ball Nut (F)
Mounting Screw (B)
Support Rod (G)