Installation Guide

ASSEMBLY AND INSTALLATION
INSTRUCTIONS
WARNING: BE SURE TO SHUT OFF POWER AT THE MAIN FUSE OR CIRCUIT
BREAKER BOX BEFORE INSTALLING OR SERVICING THIS FIXTURE.
NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ AND SAVE THESE INSTRUCTIONS.
CC56809 / CC56811
House Grounding Wire
Outlet Box
Wire Nut
Mounting Strap
Green Grounding Screw
Mounting Screw
Screw
Fixture Wire
Fixture Grounding Wire
1. Attach two screws to the mounting strap, and screw in 2 to 3 turns.
2. Attach the mounting strap to the outlet box using two mounting screws.
3. Pull out the outlet wires and the house grounding wire from the outlet box. Make wire connections
using the wire nuts:
---The black wires from the fixture to the black wire from the power source.
---The white wires from the fixture to the white wire from the power source.
---Attach the fixture grounding wire to the mounting strap with the green grounding screw. Then
connect it to the house grounding wire with the wire nut.
Carefully put the wires back into the outlet box.
4. Attach the ceiling pan to the mounting strap by inserting two screw heads into the key holes,
and rotate the ceiling pan until it locks in place. Then secure the screws tightly. (See Fig.1)
5. Install bulbs (included). See relamping label at socket area or packaging for maximum allowed
wattage.
6. Gently screw the protective glass tubes onto the sockets until securely.
7. Attach the glass shade to the ceiling pan and turn it clockwise until it locks with clips in place.
Caution: Do not over tighten.
8. Turn on the power at the main fuse or circuit breaker box.
Ceiling Pan
Socket
Protective Glass Tube
Clip
Glass Shade
110425
G9 Bulb Max.40W
(included)
Fig.1
Screw
Keyhole Slot