Installation Guide

For Semi-Flush:(See Fig. 6)
7. Pull out the outlet wires and the house grounding wire from the outlet box. Make wire
connections using the wire nuts:
---Connect the smooth wire (marked) from the fixture to the black wire from the power source.
---Connect the ridged wire(unmarked) from the fixture to the white wire from the power source.
---Attach the fixture grounding wire to the mounting plate with the green grounding screw. Then
connect it to the house grounding wire with a wire nut.
Carefully put the wires back into the outlet box.
8. Attach the canopy-1 to the mounting strap by inserting the top loop, and then secure with the collar.
9. Install bulbs (not included). See relamping label at socket area or packaging for maximum allowed
wattage.
10. Hook one end of the suspension rods to the loops-2, and then hook the other end of the suspension
rods to the loops-3. (See Fig.3)
Note: Make sure all the three suspension rods hook tightly each loops-2 and loops-3 one by
one.
11. Turn on the power at the main fuse or circuit breaker box.
1. Unscrew the loop-1 from the fixture.(See Figure 4)
2. Attach the canopy-2 onto the fixture, and then
secure with a washer and a hex nut.(See Figure 5)
3. Attach two screws to the mounting strap, and
then secure with two lock nuts. (You can adjust
the length of the screw if necessary.)
4. Attach the mounting strap to the outlet box by
using two mounting screws.
5. Cut the redundant wires if necessary. Pull out the
outlet wires and the house grounding wire from
the outlet box. Make wire connections using the
wire nuts:
---Connect the smooth wire (marked) from the
fixture to the black wire from the power source.
---Connect the ridged wire(unmarked) from the
fixture to the white wire from the power source.
---Attach the fixture grounding wire to the mounting
plate with the green grounding screw. Then
connect it to the house grounding wire with a
wire nut.
Carefully put the wires back into the outlet box.
6. Unscrew two bolt nuts from the canopy-2, attach
the canopy-2 to the mounting strap, and then
secure with two bolt nuts.
7. Follow steps 9~11 as For Pendant.
Washer
Hex Nut
Canopy-2
Figure 4 Figure 5
Figure 6
Fixture
Fixture
Nipple-2
Fixture
Nipple-2
Loop-1
Mounting Parts For Semi-Flush
Bolt Nut
Lock Nut
Fixture wire
Outlet Box
Wire Nut
Screw
Mounting Strap
Green Grounding Screw
House Grounding Wire
Fixture Grounding Wire
Mounting Screw
Canopy-2
100611
Page 2