Installation Guide

1. Pull out the wires and grounding wire from the post. Make wire connections using
the wire nuts:
---The black wire from the fixture to the black wire from the post.
---The white wire from the fixture to the white wire from the post.
---The grounding wire from the fixture to the grounding wire from the post.
Carefully tuck the wires back into the post.
2. Place the post cap on the post, then secure it with the set screws.
3. Attach the candle tubes onto the sockets, then install bulbs (not included). See
relamping label at socket area or packaging for maximum allowed wattage.
4. Secure the stem into the coupling using a hex nut.
5. Attach the dome to the frame by inserting the stem, then secure it with a rubber pad
and finial.
6. Turn on the power at the main fuse or circuit breaker box.
070210
ASSEMBLY AND INSTALLATION
INSTRUCTIONS
WARNING: BE SURE TO SHUT OFF POWER AT THE MAIN FUSE OR CIRCUIT
BREAKER BOX BEFORE INSTALLING OR SERVICING THIS FIXTURE.
ED-OPU090
Grounding Wire
Fixture Wire
Wire Nut
Set Screw
Post Cap
Post
Socket
Finial
Rubber Pad
Dome
Frame
Stem
Candle Tube
Hex Nut
Coupling
NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ AND SAVE THIS INSTRUCTION.