Installation Guide

ManualsBrandsCascadia ManualsChandeliersEmpire 12-Light Phoenician Platinum Traditional Shaded Chandelier

070602

EP-CHS012 --- Page 1

Structure Chart

ASSEMBLY AND INSTALLATION

INSTRUCTIONS

WARNING: BE SURE TO SHUT OFF POWER AT THE MAIN FUSE OR CIRCUIT

BREAKER BOX BEFORE INSTALLING OR SERVICING THIS FIXTURE.

EP-CHS012

NOTE: Before installing, consult local electrical codes for wiring and grounding requirements.

Fixtures weighing over 50 lbs must be supported independently of the outlet box. Supplied with

safety steel cord for hanging safety assurance.

The total fixture weight is 99 lbs (45 kg).

To reduce the risk of personal injury, put on gloves when servicing this fixture.

Please read the instruction carefully before installing this fixture.

Clamp

Set Screw

Safety Steel Cord

Outlet Box

Nipple(-b)

Fixture Wire

Fixture Grounding Wire

Nipple(-a)

Connector

Set Screw

Ceiling Structure

Member

House Supply And

Grounding Wires

Wire Nut

3/4" Hole

Big Metal Pad

Lock Nut

Top Loop

Loop Lock

Loop

Chain

Canopy

Collar

Nipple(-c)

Twist the locking tube

to open or close loop

lock

Connector

Fixture Wires

Fixture Grounding Wire

5/8"

10"

Loop lock

Fig.1

Fig.2

Set Screw

Clamp

Knot

Safety Steel

Cord

Fig.3

Nipple(-a)

Nipple(-b)

Set Screw

Connector

1/2"

Fig.4

Flat Pad

Candle Tube

Shade

Harp

Socket

Hex Nut

Washer

Nipple(-d)

Crystal Drop

(# X-DP080EP x 8 sets)

Crystal Drop

(# X-DP100EP x 4 sets)

Crystal Drop

(# X-DP100EP x 8 sets)

Crystal Drop

(# X-DP100EP x 8 sets)

Crystal Drop

(# X-DP100EP x 4 sets)

Finial

Coupling

Fixture

Cover Set

Arm

Crystal Ball

(# X-CB080EP)

Summary of content (2 pages)

PAGE 1
ASSEMBLY AND INSTALLATION INSTRUCTIONS EP-CHS012 WARNING: BE SURE TO SHUT OFF POWER AT THE MAIN FUSE OR CIRCUIT BREAKER BOX BEFORE INSTALLING OR SERVICING THIS FIXTURE. NOTE: Before installing, consult local electrical codes for wiring and grounding requirements. Fixtures weighing over 50 lbs must be supported independently of the outlet box. Supplied with safety steel cord for hanging safety assurance. The total fixture weight is 99 lbs (45 kg).
PAGE 2
Installation Steps: 1. This heavy fixture requires a means of support independent of the outlet box. Remove the knockout slug from the inside top center of the outlet box, and then drill a 3/4 inch diameter hole through the ceiling structural member. The fixture will be installed directly onto the ceiling structural member. Before starting assembly, it is important to make sure that the ceiling structural member can at least support four times weight of the fixture.