Installation Guide

Turn on the power at fuse or circuit box.
13. Install bottom bulbs (Included).
a. Attach the suction cap to the top surface of the bulb lens.
b. Insert and twist the bulb (LED GU10 BASE ONLY) into the socket of the lamp holder using the suction cap.
c. Remove the suction cap from the bulb lens by pulling the knob of the suction cap.
Note: Do not discard the suction cap, it will be needed when replacing the bulb.
14. Choose a mode by turn the 3 - way switch on the side of the fixture.
a. Turn the 3 - way switch clockwise, the bottom light will turn off and the side lights will brighten.
b. Turn the 3 - way switch clockwise again, the bottom light will brighten and the side lights will turn off.
c. Turn the 3 - way switch clockwise again, all lights will brighten.
171104
Threaded Pipe
Bolt Nut (G)
Upper Rod
Lower Rod
Knob
LED GU10 Bulb
Max.5W (included)
Twist the locking
tube to open or
close loop lock
Loop lock
Figure.1
Outlet Box
Housing Grounding Wire
wire connector (F)
Fixture Wire
Fixture Grounding Wire
Mounting Plate (A)
Green Grounding Screw (B)
Fixture Mounting Screw (D)
Lock Nut (E)
Canopy (K)
Mounting Screw (C)
Bulb Type A
Max.60W
(not included)
Socket Ring
Glass Shade
Loop Lock (H)
Washer (I)
Hex Nut (J)
Tube
hanger
Loop
Main Fixture
Socket
Suction Cap (K)
3-Way Switch
Metal Pad
Flat Washer