Installation Guide

LK33053 --- Page 1
ASSEMBLY AND INSTALLATION
INSTRUCTIONS
WARNING: BE SURE TO SHUT OFF POWER AT THE MAIN FUSE OR CIRCUIT
BREAKER BOX BEFORE INSTALLING OR SERVICING THIS FIXTURE.
NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. The combined weight of your ceiling fan and light kit cannot exceed 35 pounds unless
additional support is provided for the fan.
LK33053
WARNING:
As per EPACT 2005 requirements, this fan light has a built-in current
limiting device to conserve energy. The fan light will not operate if the
combined wattage of the installed bulbs exceeds 190 Watts. If the fan
light shuts off shortly after being switched on, it may be due to
excessive current demand. Turn off power to the fan and replace the
light bulbs with lower wattage bulbs.Turn on power to the fan, using
the pull chain, wall switch, or remote control (whichever is installed
on the particular fan).
Fig.1
Motor
Switch Box
White Wire
Hex Nut
Screw
Switch Box
Cover
Nipple
Light Kit
Black Wire
Wire Nut
Washer
Center Plug
Fig.3
1. Remove the switch box cover from the switch
box of the fan by loosing the three screws.
2. Unscrew the center plug from the switch box
cover and discard it.
3. For fan as Fig.1: Attach the nipple of the light kit to the hole of the switch box cover. Thread
the wires through the washer and hex nut, then secure them tightly.
4. For fan as Fig.2: Thread the wires of the light kit through switch box, then attach the light kit
to the switch box and secure it with two set screws (6x32 20mmL).
5. Pull out the outlet wires from the switch box. Make wire connections using the wire nuts:
---The smooth (marked) wire from the light kit to the black or blue wire from the fan.
---The ridged (unmarked) wire from the light kit to the white wire from the fan.
---Carefully put the wires back into the switch box.
6. Restore the switch box cover back to the switch box using the three screws.
7. Attach the clips of the shades onto the candle tubes. (See Fig.3)
8. Install bulbs (included). See relamping label at socket area or packaging for maximum
allowed wattage.
9. Turn on the power at the main fuse or circuit breaker box.
(You can control the lights with the pull chain.)
Fig.2
Shade
Clip
Candle Tube
Bulb Type B Max.60W
(included)
For Light Kit:
Light Kit
Nipple
(6 x 32 20mmL)
Set Screw
Black(Blue Wire)
Screw
Wire Nut
Smooth Wire
Smooth Wire
Motor
Switch Box Cover
White Wire
Terminal (Groove)
Terminal ( Tongue)
Ridged Wire
Ridged Wire
Switch Box
F A N C O
120813