Installation Guide

LK38312 --- Page 1

ASSEMBLY AND INSTALLATION

INSTRUCTIONS

WARNING: BE SURE TO SHUT OFF POWER AT THE MAIN FUSE OR CIRCUIT

BREAKER BOX BEFORE INSTALLING OR SERVICING THIS FIXTURE.

NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.

2. The combined weight of your ceiling fan and light kit cannot exceed 35 pounds unless

additional support is provided for the fan.

LK38312

1. Remove the switch box cover from the switch box of the fan by loosing the three switch box screws.

2. Unscrew the center plug from the switch box cover and discard it.

3. Thread the fixture wire through the switch box cover.

4. Attach nipple(-a) of the light kit to the switch box cover, then secure it with a washer and hex nut.

5. Cut the redundant wires if necessary. Pull out the wires from the switch box. Make wire connections

using the wire nuts:

---The black wire from the fixture to the black (or blue) wire from the switch box.

---The white wire from the fixture to the white wire from the switch box.

Carefully tuck the wires back into the switch box.

6. Attach the switch box cover back to the switch box using the three switch box screws.

7. Install bulbs (not included). See relamping label at socket area or packaging for maximum allowed

wattage.

8. Thread the pull chain through the glass shade and the finial. Carefully attach the glass shade to the

pan by inserting nipple(-b), then secure it with the finial.

9. Turn on the power at the main fuse or circuit breaker box. (You can control the light with the pull chain.)

For Light Kit:

Center Plug

Wire Nut

Black or Blue Wire

Black Wire

White Wire

Switch Box

Motor

Hex Nut & Washer

Nipple(-a)

Switch Box Cover

Cap

Switch Box Screw

Nipple(-b)

Glass Shade

Pan

Socket Set

Finial

Pull Chain

060218

PAGE 1
ASSEMBLY AND INSTALLATION INSTRUCTIONS LK38312 WARNING: BE SURE TO SHUT OFF POWER AT THE MAIN FUSE OR CIRCUIT BREAKER BOX BEFORE INSTALLING OR SERVICING THIS FIXTURE. NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements. 2. The combined weight of your ceiling fan and light kit cannot exceed 35 pounds unless additional support is provided for the fan.
PAGE 2
For Ceiling Light: (See Fig.1) Mounting Parts for Ceiling Light 1. Take out the the coupling, two hex nuts, washer, nipple(-c), top cap, canopy, washer and grounding pad from the Outlet Box hardware package for ceiling light. House Grounding Wire 2. Secure the coupling to nipple(-d), then screw nipple(-c) Wire Nut into the coupling and secure it with a washer and hex nut. Screw 3.