Installation Guide

assembly@@and@@installation@
@@@@@@@@@@@@@@@@@@instructions
warningZ
@@@to@avoid@risk@of@electrical@shockN@be@sure@to@shut
off@power@while@installing@or@servicing@this@fixtureN
noteZ@bˆ‰•˜ˆ@Œ”™š„’’Œ”ŠL@†•”™›’š@’•†„’@ˆ’ˆ†š˜Œ†„’@†•‡ˆ™@‰•˜@žŒ˜Œ”Š@„”‡@Š˜•›”‡Œ”Š@˜ˆ—›Œ˜ˆ“ˆ”š™N@@
OW3112
1.Thread the 2 longger screws through cross bar outwards. Attach the cross bar
to outlead box by screwing 2 mounting screws inwards.
2.Make wire connections:
---Attach black wire from light to black wire from power source with wire nut.
---Attach white wire from light to white wire from power source with wire nut.
---Attach the ground wire and house ground wire to cross bay with a
green ground screw.
3.Attach the fixture to cross bar by inserting the 2 outward screws and then
secure with 2 ball nuts.
4.Install bulbs.(Please do not exceed the maximum capacity which is
recommended on the socket)
5.Remove 2 ball nuts inside of round metal, then set the prop to round metal
and secure with the ball nuts.
6.Thread the dome, the cap and the top cup through the nipple and then
secure with the top finial.
7.Secure the threaded nipple to the coupling of the fixture, then attach
the tail and the bell to the threaded nipp;e, and then secure with finial.
8.Turn power on at fuse or circuit box.
Top Finial
Top Cup
Cap
Dome
Nipple
Prop
Ball Nut
Ball Nut
Ball
Tail
Back Plate
Screw
Wire Nut
Outlet Box
Cross Bar
Ground Wire
Mounting Screw
Fixture Wire
Ground Screw
Finial
Round Metal
Fixture
Coupling
Threaded Nipple
Installation Steps