Installation Guide

OW39553
070712
Mounting Screw
Headless Screw
Fixture Wire
Lock Nut
Bolt Nut
Cross Bar
House Grounding Wire
Green Grounding Screw
Fixture Grounding Wire
Wire Nut
Outlet Box
Back Plate
Fixture
1. Thread two headless screws through the cross bar, then secure them with four
lock nuts (two on each side of the cross bar). Adjust the length of the headless
screws if necessary.
2. Attach the cross bar to the outlet box by using two mounting screws.
3. Pull out the outlet wires and the house grounding wire from the outlet box. Make
wire connections using the wire nuts:
---Connect the black wire from the fixture to the black wire from the power source.
---Connect the white wire from the fixture to the white wire from the power source.
---Attach the fixture grounding wire to the mounting plate with the green grounding
screw. Then connect it to the house grounding wire with a wire nut.
Carefully put the wires back into the outlet box.
4. Attach the back plate to the cross bar by inserting headless screws, then secure it
with two bolt nuts.
CAUTION: With silicone caulking compound, caulk completely around where
the back plate meets with the wall surface to prevent water from seeping into
the outlet box.
5. Install a bulb (not included). See relamping label at socket area or packaging for
maximum allowed wattage.
6. Turn on the power at the main fuse or circuit breaker box.
ASSEMBLY AND INSTALLATION
INSTRUCTIONS
WARNING: BE SURE TO SHUT OFF POWER AT THE MAIN FUSE OR CIRCUIT
BREAKER BOX BEFORE INSTALLING OR SERVICING THIS FIXTURE.
NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ AND SAVE THIS INSTRUCTION.