Installation Guide

ManualsBrandsCascadia ManualsCeiling Light MountsSolstice Burnished Bronze Metal Ceiling Light Mount

Side Rod

Nipple

Fixture

Frame

Dry Wall Screw

Wall Anchor

Setting Hole

ASSEMBLY AND INSTALLATION

INSTRUCTIONS

WARNING: BE SURE TO SHUT OFF POWER AT THE MAIN FUSE OR CIRCUIT

BREAKER BOX BEFORE INSTALLING OR SERVICING THIS FIXTURE.

NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.

2. READ AND SAVE THESE INSTRUCTIONS.

P0025

120116

Collar

Center Rod

Nipple

Buckle

Fig.1

Outlet Box

House Grounding Wire

Wire Nut

Fixture Wire

Grounding Wire

Mounting Strap

Green Grounding Screw

Mounting Screw

Fig.3

Fig.4

Fig.2

Fig.2.1.

Frame

Finial

Canopy

Swivel

Frame

Fixture wire

Setting Hole

Outlet Box

Mounting Strap

Mounting Screw

Nipple-1

coupling

Hex Nut

Washer

Hex Nut

Collar

Canopy

Nipple

Set Screw

Nipple

Summary of content (3 pages)

PAGE 1
ASSEMBLY AND INSTALLATION INSTRUCTIONS P0025 WARNING: BE SURE TO SHUT OFF POWER AT THE MAIN FUSE OR CIRCUIT BREAKER BOX BEFORE INSTALLING OR SERVICING THIS FIXTURE. NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements. 2. READ AND SAVE THESE INSTRUCTIONS. Fig.1 Fig.2 Outlet Box Hex Nut Washer Mounting Strap Finial Fig.
PAGE 2
1. Carefully unpack the fixture, lay out the fixture Fig.5 on a clean surface. 2. Remove and save the finial. (Fig.1) Wall Plug 3. Install a hex nut onto one end of the nipple-1 Setting Hole Long Screw leaving about 3/8” (10mm) thread exposed. Frame Install same end of nipple-1 by screwing into coupling, secure nipple-1 by tightening the hex Set Screw nut, attach the nipple to the coupling. (Fig. 2) 4. Attach the nipple-1 to the mounting strap, Nipple then secure it with a washer and hex nut. Buckle 5.
PAGE 3
10. Attach the buckles onto setting holes. 11. Cut any excess fixture wires leaving only about 8" (20cm) length from the top end of nipple-1, then strip off 3/4"the fixture wires of plastic from each end. 12. Pull out the outlet wires and house grounding wire from the outlet box. Make wire connections using the wire nuts: ---All black wires from rods to the black wire from power source. ---All white wires from rods to the white wire from power source.