Installation Guide

ASSEMBLY AND INSTALLATION
INSTRUCTIONS
NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ AND SAVE THESE INSTRUCTIONS.
P0155 / P0156
WARNING:
TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF
POWER WHILE INSTALLING OR SERVICING THIS FIXTURE.
Wire Nut P3 (E)
(12PCS)
Anchor(A)
(4PCS)
Mounting Screw(B)
(2PCS)
Dry Wall Screw(C)
(4PCS)
Wire Nut P5(D)
(3PCS)
Hardware Package (included):
Power cord(F)
(White+Black)
(4 SETS)
Grounding cord(G)
(Green) (4 PCS)
141210
Page 1
Turn off the power at fuse or circuit box.
Installation Steps
1. Carefully unpack the fixture, lay out the fixture on a clean surface.
2. Remove the mounting plate from canopy by unscrewing four ball nuts.
3. Use suitable tools to unscrew the hex nuts from the canopy, remove the threaded pipe and finial from the canopy. Save
the finial for later. (See Fig.1)
4. Fix the mounting plate to the ceiling.
a) For wooden material:
Attach the mounting plate to the outlet box by using two mounting screws, and then secure the dry wall screws
through the set holes to the ceiling.
b) For cement material:
Place the mounting plate to the outlet box and mark the target on the ceiling from the set hole for drilling two holes.
Remove the mounting plate from the outlet box. Thread the anchors into the holes, then attach the mounting plate
to the outlet box by using two mounting screws. Secure the dry wall screws through the set holes into the anchors.
Finial
Ball Nut
Anchor(A)
Long Screw
Mounting Screw(B)
Lock Nut
Mounting Plate
Reinforcing Plate
Dry Wall Screw(C)
Threaded Pipe
Hex Nut
Canopy
Fig.1