Installation Guide

161120
Turn on the power at fuse or circuit box
Finial (G)
Mounting Plate (A)
Green Grounding
Screw (E)
Fixture Mounting
Screw(D)
Mounting Screw (B)
Wire Connector (C)
Lock Nut (F)
4. Pull out the source wires from the outlet box. Make wire
connections using wire connectors as follows:
---Connect the black wire from the fixture to the black wire
from the power source.
---Connect the white wire from the fixture to the white wire
from the power source.
---Attach the fixture grounding wire to the mounting plate with
the green grounding screw, and then connect it to the
house grounding wire with a wire connector.
Carefully put the wires back into the outlet box.
5. Attach the fixture canopy to the mounting plate by inserting the
fixture mounting screws, and then secure it with two
ball nuts.
6.Angled mounting recommended for a vaulted or angled
ceiling. (See Fig. 1)
The following parts are available for re-order if damaged or missing.
Spare Parts List:
Mounting Hardware
(1 SET)
5676MM For P0211 / P0214
5677MM For P0212 / P0215
5670MM For P0213 / P0216
Fig. 1
Outlet Box
Support Brace
Canopy
Coupling Kit
Function and Operation
TURNING LIGHTS ON, OFF
Wave hand under 4 inches of
sensor once to turn light on or off.
LOCK / UNLOCK LIGHT
Wave hand under 4 inches of sensor
within 0. 5 seconds twice to lock or
unlock sensor.
NOTE: Dimming ranges from 100%
to 5% brightness.
DIMMING LIGHTS
Hold hand under 4 inches of sensor
to adjust brightness.
1x
ON-OFF
2x
LOCK-UNLOCK
DIMMING
PC Diffuser X1
9864AC For P0211/P0212/P0213
9865AC For P0214/P0215/P0216
7253DD For P0211/P0212/P0213
7152DD For P0214/P0215/P0216
Lock Ring X1
7151LR
Driver X1