Installation Guide

181206
8. Attach the fixture canopy to the mounting plate by inserting the
fixture mounting screws, and then secure it with two ball nuts.
9. Angled mounting recommended for a vaulted or angled
ceiling. (See Fig. 1)
Turn on the power at fuse or circuit box.
Fig. 1
Outlet Box
Support Brace
Canopy
Coupling Kit
1. Thread two fixture mounting screws to the mounting plate,
and then secure with two lock nuts. Adjust the length of the
fixture mounting screws if necessary.
2. Attach the mounting plate to the outlet box by using two
mounting screws.
3. Thread the fixture wire from the fixture through the rod,
and then secure the lower rod onto fixture using the threaded pipe.
4. Thread the fixture wire through the fixture canopy, and then
secure the rod assembly to the coupling kit of the fixture canopy.
5. Pull out the source wires from the outlet box. Make wire
connections using wire connectors as follows:
---Connect the smooth-coated wire (marked) from the fixture
to the black wire from the power source.
---Connect the ribbed-coated wire (unmarked) from the fixture
to the white wire from the power source.
---Attach the fixture grounding wire to the mounting plate with
the green grounding screw, and then connect it to the
house grounding wire with a wire connector.
Carefully put the wires back into the outlet box.
6. Put the glass into the trapezoidal frame, always keep the smooth side
of the glass face out, press the small iron shim in the frame onto the
glass and make sure it is tight.
7.
Install bulbs (not included). See relamping label at socket area or
packaging for maximum allowed wattage.
8. Attach the canopy to the mounting plate by inserting the fixture mounting screws, then secure it with two ball nuts.
For Semi-Flush
Turn off the power at fuse or circuit box
Turn on the power at fuse or circuit box
Fixture Canopy
Ball Nut(G)
Coupling Kit
Rod
Bulb Type A
Max.60W
(not included)
Socket
Fixture