Installation Guide

ManualsBrandsCascadia ManualsPost Light PartsSonnet 100-Watt 17.5-in Gold Stone Distressed Traditional Post Light

1. Take a glass panel and gently slide the narrow side of the glass panel down into the metal

frame in place, secure it by pressing the clips from both top and bottom sides.

(See Fig.1 & Fig.2) Repeat with other panels.

2. Pull out the wires and grounding wire from the post. Make wire connections using the wire

nuts:

---The black wire from the fixture to the black wire from the post.

---The white wire from the fixture to the white wire from the post.

---The grounding wire from the fixture to the grounding wire from the post.

Carefully put the wires back into the post.

3. Place the fitter on the post, then secure it with the fitter screws.

CAUTION: With silicone caulking compound, caulk completely around where the fitter

meets with the post surface to prevent water from seeping into the post.

4. Install a bulb (not included). See relamping label at socket area or packaging for maximum

allowed wattage.

5. Attach the metal frame to the dome and secure it with the screws.

6. Turn on the power at the main fuse or circuit breaker box.

ASSEMBLY AND INSTALLATION

INSTRUCTIONS

WARNING: BE SURE TO SHUT OFF POWER AT THE MAIN FUSE OR CIRCUIT

BREAKER BOX BEFORE INSTALLING OR SERVICING THIS FIXTURE.

T0032

NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.

2. READ AND SAVE THESE INSTRUCTIONS.

Grounding Wire

Fixture Wire

Fitter Screw

Wire Nut

Post

Fitter

Glass Panel

Dome

Metal Frame

120229

Contents of Spare Parts:

Assembly Kit

(1 SET)

(4412MM)

Glass Shade

(4 PCS)

(9290S)

Clips

Glass Panel

Fig.1

Fig.２

Clips

Bulb Type A Max.100W

(not included)

Clips

Glass Panel

Screw

Photocell

IMPORTANT:

The sensor has an excellent photocell function

to enable the light to turn on at dusk and off at

dawn automatically.

Screw

(2 PCS)

(4412SS)

Summary of content (2 pages)

PAGE 1
ASSEMBLY AND INSTALLATION INSTRUCTIONS T0032 WARNING: BE SURE TO SHUT OFF POWER AT THE MAIN FUSE OR CIRCUIT BREAKER BOX BEFORE INSTALLING OR SERVICING THIS FIXTURE. NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements. 2. READ AND SAVE THESE INSTRUCTIONS. Contents of Spare Parts: Screw (2 PCS) (4412SS) Assembly Kit (1 SET) (4412MM) Dome Glass Shade (4 PCS) (9290S) Glass Panel Bulb Type A Max.
PAGE 2
Operation the Unit Without Photocell Photocell White Wires From Photocell Black Wires From Photocell Wires From Fixture White Wire From Fixture Black Wire From Fixture Red Wires From Photocell Plate Washer Wire Nuts Pigtail Wire Nut White Pigtail Hex Nut Fig.1 Wires From Main Power Fig.2 1. Turn off the power at the main fuse or circuit breaker box before starting installation. 2. Unscrew the hex nut and washer to remove the plate from the fixture. 2.