Installation Guide
T0068 --- Page 1 / 5
Important to Know
1. Read all instructions carefully before installation
and operation.
2. If you are not familiar with state and local electrical
codes, it is recommended that you consult with a
qualified electrician.
3. Before installation, shut off power at the main fuse
or circuit breaker box. Be aware that simply turning
off the wall switch is not sufficient to prevent an
electrical shock.
4. This fixture requires a 120 VAC, 60 Hz power
source.
5. For general safety and to avoid any possible
damage to the sensor, be sure the power is
switched "off" before adjustment.
6. This product is intended for use with the enclosed
gasket and with a junction box marked for use in
wet locations.
Maximum Wattage: 25W±2.5W
Work Temperature: -4
0
F ~ 104
0
F
ASSEMBLY AND INSTALLATION
INSTRUCTIONS
WARNING: BE SURE TO SHUT OFF POWER AT THE MAIN FUSE OR CIRCUIT
BREAKER BOX BEFORE INSTALLING OR SERVICING THIS FIXTURE.
NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ AND SAVE THESE INSTRUCTIONS.
T0068
Features
1. Energy saving LED fixture.
2. LED light Turns on automatically when
motion is detected.
3. LED light will turn off automatically after
people leave.
4. PC' Mode provides illumination from
dusk to dawn.
5. When in manual override mode, use
wall switch to keep the light ON in the
night.
131114
Parts:
Parts Number (4540MM)
Mounting Screw (B)
Mounting Strap (A)
Rubber Pad (C)
Set Screw (D)
Decorative Cover (E)
Wire Nut (F)