Installation Guide

T0068 --- Page 4 / 5
131114
FIG.7 (View from Bottom of Sensor)
Shut-off Delay
The Shut-off delay is the time of the light will stay at brightness
after motion has ceased to be detected. This Shut-off delay can
be set by using the “TIMER” knob located on the left side of the
panel at the bottom of the sensor (See Fig.7). To increase
shut-off delay, slide the knob clockwise. To decrease shut off
delay, turn the knob counterclockwise. The light will stay on as
long as motion is detected and will automatically turn off when
no more motion is detected after the delay time has passed.
CUSTOMIZATION OPTIONS:
OFF Mode
AUTO Mode
Manual
Override
Manual Override Operation Diagram
Turn wall switch OFF-ON
in 0.5~3 Seconds
Turn wall switch OFF over
5 Seconds and then turn
ON again
Fig.6
4. PC` MODE (nighttime operation only; on at dusk, off at dawn)
The lights will brighten at dusk. Lights will turn off
automatically at dawn
5. Manual Override (nighttime operation only; on at dusk, off
at dawn)
Set the switch at “OFF” or “AUTO” position, the light will
be turn on in all night by switching the power off for 0.5
seconds~3 seconds then on again. Turn the power off for
5 seconds, the light will return to “OFF” mode or “AUTO”
mode. (See Fig.6)
Light will turn off automatically at dawn.
Fig.7
Motion
Least sensitive
Motion
Most sensitive
Sensor
10'
6.0'
13.0'
60'
Fig.8
Fig.9
NOTE:
1. The sensitivity of the motion sensor will increase as the
environmental temperature gets cooler. You may wish to
make adjustments when the season changes temperature.
For best performance. Gently clean the lens with a soft
cloth every 1 or 2 months to assure maximum sensitivity.
2. The magnitude of adjustment for sensitivity and time may
not be precisely proportionate to the amount the knob is
turned.
3. For best performance, install fixture at least 6 feet above the
ground. At such a height, the fixture will provide a detection distance of up to 60 feet at 77 degrees
Fahrenheit. (See FIG.8)
4. The sensor detects across a detection range of 240 degrees. (See FIG.9)
5. The sensor will be more sensitive to motion across its detection path than motion directly towards it.
(See FIG.10)
6. To reduce possible nuisances, do not mount the fixture near a heat source like an air conditioner, vent or
furnace exhaust, or in a direction facing any reflecting object or other light source.
Where you install your fixture is important:
Be sure the light is mounted straight on the wall;
otherwise, the detection distance may be limited.
240'
Sensitivity of Motion Sensor
The sensitivity of the motion sensor can be adjusted using the “SENSITIVITY” knob located on the right side of
the panel at the bottom of the sensor (See Fig. 7). To increase sensitivity, slide the knob clockwise. To decrease
sensitivity, slide the knob counterclockwise. The sensitivity may be adjusted from a minimum of 10 feet to a
maximum of 60 feet.
Fig.10