Installation Guide
T0068 --- Page 5 / 5
131114
A
B
C
A: 7-1/2˝ B: 12-1/2˝ C: 6-1/2˝
Troubleshooting
---The light does not come on at all:
1. Make sure the wall switch and circuit breaker are on.
2. Make sure the wiring is correct.
3. Cover the sensor with dark color cloth to verify that the ambient light level is not too high.
---In TEST Mode, the light stays on over 5 seconds after motion is no longer detected:
1. Make sure the slide switch is at the TEST position.
2. Cover the sensor with a dark color cloth to verify that motion is not detected.
---In OFF Mode, the light stays on over 180 seconds after motion is no longer detected:
1. Make sure there is not motion could be detected by the sensor.
2. Make sure of that mode entry is not in manual override.
---In AUTO Mode, the light stays on over 180 seconds after motion is no longer detected:
1. Make sure there is no movement that could be picked up by the sensor.
2. Make sure of that mode entry is not in manual override.
---In PC` Mode, the light stays on after dawn:
1. Whether the ambient light level is too low.
---In Manual override, the light stays on after dawn:
1. Whether the ambient light level is too low.
---If the sensor out of the ball joint, loose the clamp screw and push the
sensor back into the ball joint. Tighten the clamp screw when done.