Installation Guide

ASSEMBLY AND INSTALLATION
INSTRUCTIONS
WARNING: BE SURE TO SHUT OFF POWER AT THE MAIN FUSE OR CIRCUIT
BREAKER BOX BEFORE INSTALLING OR SERVICING THIS FIXTURE.
NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ AND SAVE THESE INSTRUCTIONS.
T0076
Dome
Parts:
140328
Parts Number (4996MM)
Wire Nut (B)
Metal Frame
Ball Nut Assembly (D)
Post Grounding Wire
Fixture Wire
Wire Nut (B)
Post
Fitter
Fixture Grounding Wire
Fitter Screw (A)
Bulb Type B Max.60W
(not included)
Fitter Screw (A)
Parts Number (9593CS)
Glass Panel (C) (X4)
Parts Number (4998SS)
Ball Nut Assembly (D) (X2)
Glass Panel (D)
Clip
Fig.1
Clip
Glass Panel
Clip
Glass Panel
Photocell
1. Take a glass panel and gently slide it into the frame in place, then press the clips which on the top
of the metal frame and the clips which on the bottom of the metal frame to secure them.(See Fig.1)
Repeat with other glass panels.
2. Pull out the outlet wires and the house grounding wire from the outlet box. Make wire connections
using the wire nuts:
---Connect the black wire from the fixture to the black wire from the power source.
---Connect the white wire from the fixture to the white wire from the power source.
---Attach the fixture grounding wire to the cross bar with the green grounding screw. Then connect
it to the house grounding wire with a wire nut.
Carefully put the wires back into the outlet box.
IMPORTANT:
The sensor has an excellent photocell function to enable the light to turn on at dusk and off at dawn
automatically.