Installation Guide

ASSEMBLY AND INSTALLATION
INSTRUCTIONS
NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ AND SAVE THESE INSTRUCTIONS.
T0095
Loop
Nipple
Glass Shade (C)
Socket
Parts:
140320
Parts Number (5013MM)
Parts Number (9582CS)
Wire Nut (B)
Glass Shade (C)
Metal Frame
Set Screw
Post Grounding Wire
Fixture Wire
Wire Nut (B)
Post
Fitter
Fitter Screw (A)
Bulb Type A Max.100W
(not included)
Fitter Screw (A)
Photocell
IMPORTANT:
The sensor has an excellent photocell function
to enable the light to turn on at dusk and off at
dawn automatically.
1. Secure the loop to the nipple.
2. Install a bulb (not included). See relamping label at
socket area or packaging for maximum allowed wattage.
3. Take glass shade and gently slide it into the metal frame
in place, then attach the fixture onto the metal frame
by aligning holes, screw the set screws from the holes of
the fixture into the holes on the bottom of the metal
frame.
4. Pull out the post wires and the house grounding wire
from the post. Make wire connections by using the wire
nuts:
---Connect the black (hot) wire from the fixture to the
black (hot) wire from the post.
---Connect the white (neutral) wire from the fixture to
the white (neutral) wire from the post.
---The grounding wire from the fixture to the grounding
wire from the post.
Carefully put the wires back into the post.
5. Place the fitter on the post, then secure it with three
fitter screws.
Note: With silicone caulking compound, caulk
completely around where the fitter meets with the
post surface to prevent water from seeping into the
post.
6. Turn on the power at the main fuse or circuit breaker box.
Fixture
WARNING: Turn off the main power at circuit breaker before installing fixture.
AVERTISSEMENT: Coupez la source d’alimentation principale au panneau
central de disjoncteurs avant d’installer le luminaire.