Installation Guide

Installation Steps

1. Shut off power at the circuit breaker of where the fixture is to be installed.

2. Attach the mounting strap to the outlet box by using two mounting screws.

3. Pull out the outlet wires from the outlet box. Make wire connections using the wire nuts:

---Connect the black wire from the fixture to the black wire from the power source.

---Connect the white wire from the fixture to the white wire from the power source.

Carefully put the wires back into the outlet box.

4. Attach the back plate to the mounting strap, secure it with a rubber pad and set screw.

5. With silicone caulking compound, caulk completely around where the back plate meets the wall surface.

Note: Be sure to caulk completely where the back plate meets the wall surface to prevent water from

seeping into the outlet box.

6. Push the decorative cover firmly into place.

7. Turn on the power at the main fuse or circuit breaker box.

Page 2 / 5

Sensor

Mounting Strap (A)

Wire Nut (F)

Outlet Box

Fixture Wire

Back Plate

Mounting Screw (B)

LED Lamp Head

Decorative cover (E)

Rubber Pad (C)

Set Screw (D)

140613

NOTES:

Wall wash light options：

1. Option 1: Up & Down light accent, the original setting of wall wash light is the up and down light accent.

2. Option 2: Down light accent only, unplug the connectors ( 1 and 3 , 2 and 4 ). (See Fig. 1) Then connect

the connectors ( 1 and 2 , 3 and 4 ). (See Fig. 2)

Slip rubber hose to fully cover the connectors ( 1 2 3 4 ). (See Fig. 3 / Fig. 4)

3. Option 3: If you don't need the wall wash accent light, unplug the connectors ( 1 and 3 , 2 and 4 ).

(See Fig. 1) Wrap all connectors with electrical tape, then tuck all connectors into the back plate.

Fig. 1

Fig. 2

Fig. 3

Fig. 4

Rubber hose

Connector